您要查找的是不是：
- Moisture proof and no contact output, Load current 1A max. 具防潮功能并且采用无接点方式，限时控制负载电流最大1A.
- output load current 输出负载电流
- Synchronous rectification circuitry allows the load current to flow through the low RDS(on) of the DMOS output driver during current decay. 同步整流电路允许负载电流在电流衰减过程中通过DMOS输出驱动器的低RDS(on)流动。
- When the load current is up to the over-current value, the output will stop and the alarm relay will act, and the red LED will light. 负载电流达到过流保护设定值后即:停止输出、报警继电器动作、红色LED灯直亮。
- Industry trends lean toward lower output voltages, more power, tighter power regulation, and faster response to changes in load current. 业界之发展趋势是要求更低的输出电压、更大的功率、更有效控制电源、以及对负载电流的转变有更快速的反应。
- Load current is set in 1.56% increments of the maximum value. 负载电流在最大值增量的1.;56%25中设置。
- In order to essentially improve microwave output power and efficiency, a new idea about magnetically insulated transmission line oscillator (MILO) is brought forward, which use most of the load current to produce microwave. 为了进一步提高MILO产生微波的功率和效率,提出了其负载电流能量全部利用来产生微波的新思想。
- When a special function resolver is loaded, the additional air gap magnetomotive force due to the load current in output winding reduces the function pricision greatly. 当特种函数旋转变压器带负载时,输出绕组中出现的电流在气隙中建立的附加磁势,引起磁场分布畸变,导致函数精度显著下降。
- When ordering overload relays, specify horsepower, voltage and full load current per motor nameplate. 订购过载继电器时，请注明每台电机的功率马力、电压和满载电流。
- The load current is handled directly by the controller through semiconductor switching devices. 负荷电流由调节器通过半导体开关元件直接控制。
- The peak load current limit is set by the user's selection of a reference voltage and current-sensing resistors. 用户可通过选择参考电压和电流感测电阻设置峰值载荷电流限制。
- An "Overcurrent Relay" is a type of protective relay which operates when the load current exceeds a preset value. 过电流继电器是继电保护装置的一种，当负载电流超过整定值时，继电器动作。
- Choosing the load current phasor as the reference for the phasor diagram analysis is straightforward and effective. 以负载电流相量为参考的新的相量图分析方法是简洁有效的；
- The current distribution in fuses is discussed when high frequency components are present in the load current. 还讨论了在负载电流中引入高频分量时熔断器中的电流分布问题。
- Consequently, no load current flows through R6 because Q2, whose base-emitter voltage is now 0V, has turned off. 由于Q2的基极-发射极的电压为0V而截止，因此没有负载电流流过R6。
- The current flows out of the output terminal. 电流从输出电极流出。
- Hard copy is computer output on paper, printing or graphics. 硬拷贝是出现在纸上、印刷上或图表上的电脑输出。
- In the test for voltage regulator, the load current of the DUT provided by the test equipment needs a certain delaytime to reach the provision value. 在电压调整器测试中,测试设备提供的负载电流需经一定的时间延迟才能达到预定值。
- The desired load current level is set via the serial port with two six bit linear DACs in conjunction with a reference voltage. 可通过有两个6位线性DAC串行接口及参考电压来设置期望的负载电流电平。
