您要查找的是不是：
- Check the engine oil level regularly. 要时常检查机油量。
- Through the oil level indicator, we check the hydraulic oil level of crane. 利用油位指示器检查起重机的液压油位。
- Inspecting the oil level of motor lubrication. 检查发动机润滑油油面。
- Inspect the hydraulic oil level of clutch. 检查离合器液压油油面。
- Add 2.0 litre5 to reach max．oil level! 添加2升以达到液位上限!
- A seal kit consists of two labyrinth seals and is supplied together with an oil pick-up ring, an oil level gauge, a magnetic plug and mounting instructions. 密封套件包含两个迷宫密封件,在提供给用户时还带有一个抛油环、一个油位表、一个磁铁油塞,以及安装说明。
- Tip: If you don't know the oil capacity of the engine, add four quarts, then check the oil level, if it's a quart low add another quart. 冰山:如果你不知道发动机油容量;加上四个石英;然后检查石油级如果是低再添一石英石英.
- If equipped with an oil level sensor, disconnect the sensor. 如果配备有油面感知器，断开感知器。
- Methods: to keep the crankshaft inside a normal oil level. 方法：保持曲轴箱内正常的机油水平。
- Message: Fixed: max security level check in. Security command, normalize player name and encode before use. Let apply this command to offline player. 修复最大安全等级检查.;security命令;在使用之前规格化玩家名字和密码;让这个命令适用未连线的玩家。
- Sealed oil chamber does not require constant monitoring of oil level. 密封的油箱,不需要经常观察油量的多少。
- It is important not to exceed the recommended oil level if leakage is to be avoided (table). 如果要避免漏油,不能超过建议的油量,这是很重要的,见表13。
- Oil level marks in the housing and an oil level gauge help to keep the correct oil level. 轴承座内的油位标记和油位表使油位保持在正确水平。
- Examine working status of the frame, degree of cleanness and oil level of lubricating oil termly. 定期检查托架的使用情况，定期检查润滑油的清洁度和油位。
- There is no dipstick for the AL4 automatic transmission, and the level checking procedure is slightly unusual. 因为AL4自动波箱系冇油呎，所以检查程序有多少特别。
- Fill oil pan 1 with JUKI Machine Oil No. 7 up to HIGH mark A.When the oil level lowers below LOW mark B, refill the oil pan with the specified oil. 请把JUKI Machine Oil No.;1机油倒进油槽1里，一直加到HIGH标记A的位置。油槽的油面降到LOW标记B以下时，请再次补充机油。
- In this paper, fiber-reinforced epoxy foam composite used as floater for indicating height of oil level in automobile braking system was investigated. 研究了纤维增强环氧发泡材料用于轿车刹车油液面指示用浮子。
- (6) Check the oil level in the lubricator. 检查注油器的油位。
- While simulating high oil temperature and high oil level failure conditions, the corresponding indicating lamp should light up and failure pre-warning messages should be sent out. 模拟油温高、油位高故障,相应的指示灯亮且应有故障预报警信号输出。
- Oil of reducer should be replaced every half year.The oil storage of reducer must be kept on prescribe oil level during operation and should not be too much. 走行减速机要定期更换润滑油。每半年更换一次。运转中，减速机体内储油量必须保持规定油位，不宜过多或过少。
