您要查找的是不是：
- Analysis of and Comparison between the Water Curing Method and Normal Pressure Steam Curing Method 热水交联与常压蒸汽交联两种工艺的分析比较
- normal pressure steam curing 常压蒸汽交联
- At normal pressures steam condenses at 100℃. 在正常的压力下，蒸气在摄氏100°时凝结成液体。
- At normal pressures steam condenses at 100oC. 在正常压力下，水蒸气在摄氏100度时凝结。
- low pressure steam curing 低压蒸气养护
- high pressure steam curing 高压蒸汽消毒器,高压蒸汽养护
- The Application of Pressure Steam Cured Concrete Blocks in Yinhai Square 蒸压加气混凝土砌块在银海广场中的运用
- This experiment can be done under normal pressure. 这个实验在常压条件下进行即可。
- The normal pressure meter is suite measure some liquate,gas,steam medium pressure which has no corruption for copper and steel. 一般压力表适用于测量爆炸危险，不结晶，不凝固及对钢和铜合金不起腐蚀作用的液体、蒸汽和气体等介质的压力。
- Can base together for High Pressure Steam disinfection. 笼盒可上下垒起来高压蒸汽灭菌;
- To put(gas or liquid) under a greater than normal pressure. 用大于正常压力对（气体或液体）施压
- Main apparatus: pressure steam sterllizer, drying apparatus, tinning apparatus. 主要设备：高温高压锅、干燥设备、袋包机（或罐装设备）等。
- Using tests of compressive strength, hydration product and porosity, the influen ce of steam curing on the pozzolanic reaction of rejected fly ash were studied. 通过研究蒸汽养护条件下含废弃粉煤灰的样品在抗压强度、水化产物以及孔隙率等方面的变化,探讨了蒸汽养护对废弃粉煤灰火山灰活性的影响。
- The corrosion cause of an autoclave for steam curing of aeroconcrete was analyzed in the paper, with the aim at obtaining anticorrosion meaeures. 摘要分析了蒸压反应釜腐蚀的原因；
- Eventually, the hose springs a leak or ruptures under normal pressure. 最后在正常压力下热水管产生裂缝或破裂.
- On similar projects, with 50m span length (single spans, cantilevering 1/5), the cycle time is usually approx. 10 - 12 days without steam curing, reinforced in-situ by hand. 类似项目50米跨（单线，1/5悬臂）没有使用蒸汽养生和预制钢筋笼，一个工作循环为10-12天。
- In order to shorten construction durations, people often apply the steam curing technology to the prefabrication of concrete box beams in many projects. 采用蒸汽养护技术预制混凝土箱梁可以提高梁的品质,缩短施工周期,该技术的难点在于严格、准确、实时地控制温度变化。
- Objective To monitor the sterilizing effect of pulsing vacuum pressure steam sterilizer. 目的:监测脉动真空压力蒸气灭菌器灭菌效果。
- The results indicate that the formation of calcium silicate hydrate is difficult at normal pressure. 结果表明,在常压下除硅,难以形成水合硅酸钙。
- After reaching the normal pressure, switch off and take down nozzle jet and plug to end inflation. 当到达正常气压后,切断启动开关,取下气嘴及插头,充气完成。
