您要查找的是不是:
- The greatest disadvantage is its low efficiency and poor fuel economy under no load or partial load conditions that constitute a significant portion of the operation of automotive vehicles. 最大的缺点是它的低效率和无负载或部分负载条件下低劣的燃油经济性,而这是构成汽车车辆运作的一个重要方面。
- When stabilizer doesn't connect with lamp, standing in no load condition, stabilizer stop working automatically. 当安定器未接灯泡,处于空载状态时,安定器自动停止工作。
- short-circuit at no load condition 空载短路
- no load conditions 空载状态
- Typical droop is two cycles in frequency from no load to full load. 从空载到满载转速降一般为两赫兹。
- What kind of load conditions will the server be under? 服务器将处于哪种负载条件下呢?
- Invalid static SUBCASE that has no load or enforced displacement. 一般从out文件查找error的位置,都能发现原因。
- no load condition 空载工况
- The measured efficiency for AHB prototype circuit reaches 92.6% under low-line input and light load conditions. 非对称半桥雏型电路在低输入电压和轻载条件下,效率可达到92.;6%25。
- Finally, buffeting responses of the suspension bridge under forty-two kinds of load conditions are calculated. 最后计算了某悬索桥在42种荷载工况下的抖振响应。
- No loading without pre-shipment inspection by Veritas. 未经过真实的检查,不得装载。
- The oil film of sliding bearing was squeezed and sheared in the dynamic load conditions. 滑动轴承在动载工作条件下运行时,承载油膜受到轴承挤压和旋转剪切两种运动作用。
- The goernor must hae proision for adjusting speed( generator frequency) and speed droop( no load to full load). 调速器必须具备转速调整(电机频率)降速降调整(负荷到满负荷)能。
- The happening of brittleness is related to the load condition. 脆性的发生和电力线路的负载状况有关;
- The governor must have provision for adjusting speed( generator frequency) and speed droop( no load to full load). 调速器必须具备转速调整(电机频率)降速降调整(负荷到满负荷)能。
- The parameters used in the analyses include rise to span ratio, slenderness ratio, steel ratio and load conditions. 分析的参数有矢跨比、长细比、含钢率以及加载方式。
- The pivot and race surfaces were true surface of revolution and were correctly centred when no load was applied. 轴枢和套圈的表面是准确的旋转表面,并在未施加载荷正确对中。
- The pivot and race surfaces were true surface of revolution and were correctly centered when no load was applied. 轴枢和套圈的表面是准确的旋转表面,并在未施加载荷正确对中。
- A constant 1.2 MHz switching frequency, with current-mode control scheme, provides stable low-noise operation at high load conditions. 恒定的1.;2 MHz开关频率及电流模式控制配置可确保高载荷条件下稳定的低噪音操作。