您要查找的是不是：
- R1 charges up the negative side of C1 to the supply voltage, VDD. R1将C1的负向充电到供电电压VDD。
- negative supply voltage 负电源电压
- Ohmic resistance measured between the supply voltage connections. 供电电路中测得的电阻(欧姆)。
- Features: Low VCE(sat),High performance at low supply voltage. 特点：饱和压降低,功率高和电压小。
- This capacitance is discharged when the supply voltage is switched on. 为什么电源电压接通时电容是放电?
- This equates to reclosing with twice the supply voltage on the motor. 这等于再合闸电机上有两倍的电源电压。
- Two wires for the supply voltage and one for the receiver's R/C sum signal. 通常没有被引出，所以我们要打开接收机找到其中的那个焊点，将它引出。
- In the event of negative supply pressure such contaminated fluids will not backflow to the supply source by backsiphonage. 万一存在这种污染流体的反压力，则要避免由于反虹吸而回流到供应水源中。
- As a result, an amplifier of this type may have outstanding low frequency power supply rejection, but the negative supply rejection is fundamentally limited at high frequencies. 因此,此类放大器会有杰出的低频供电抑制,但负电压供电会被限制在高频。
- The HL202 base drive and thick-film IC for a sort of fading-saturation and negative supply protective special GTR and its the range of pin ,name,funcion and usage are introduced. 介绍了一种带退饱和及负电源负压保护的专用GTR厚膜驱动器集成电路HL202,讨论了其引脚排列、各引脚的名称、功能和用法,给出其主要设计特点和参数限制,剖析其内部结构和工作原理,进而探讨了其应用技术,并给出应用实例。
- This paper presents a novel current source which is insensitive to supply voltage. 摘要这篇论文提出了一个和电源电压变动无关的新式电流源。
- In the event of negative supply pressures, such contaminated fluids must not be allowed to backflow to the potable water supply source by backsiphonage or other cause. 一旦出现反供应压力，如污染的流体，则必须不允许由于反虹吸或其他原因回流到饮用水供应系统中。
- Because the power supply rejection of most ADCs is fairly high, drifts in the power supply voltage do not adversely affect the measurement. 由于多数模数转换器的电源滤波是相当高,电源电压有害地偏差不影响这次测量。
- For mains-independent service in the field, the sensor can operate with a supply voltage of 6V. 传感器独立于主电源工作,可以在6伏的供电电压下运行。
- Power Supply Rejection: The ratio of the change in input offset voltage to change in power supply voltage producing it. 电源抑制比,输入失调电压变化量与引起该变化的电源电压变化量之比。
- The Voltage Selector Setting should be checked to see that it conforms to the local AC supply voltage. 必须查看本机交流电压选择器之预调状态是否符合本地交流电压。
- YOU MUST ENSURE THE BATTERY AND / OR POWER SUPPLY VOLTAGE DOES NOT EXCEED THE MAXIMUM SPECIFIED FOR YOUR SERVOS. 您必须保证电池和/ 或电源电压不超出最大值被指定为您的伺服机。
- The power supply voltage may be controlled by replacing D1, D2, R1 and R2 with a variable voltage reference. 将D1、D2、R1和R2换成一个可变参考电压源，本电路就变成了一个可控电源。
- The reference voltage, VREF, is applied externally and can be set up to the supply voltage, VDD. 基准电压（VREF）由外部提供，最高可以设置为电源电压VDD。
- Voltage generated by the motor at the instant of reclose may be equal to the supply voltage but exactly out of phase. 再合闸瞬间电机产生的电压可与电源电压相等但正好失相。
