您要查找的是不是：
- morular delamination 桑椹胚分层
- morula delamination 死亡统计
- M+B：morula and blastocyst stages. 桑椹期和囊胚期。
- Interfacial tractions at the broken ends will produce delamination. 断头处的界面引力将引起分层。
- The growth of a zygote into a morula is called fragmentation. 受精卵发育成桑椹胚的过程叫卵裂。
- Floor warping, expansion or delamination due to excess moisture. 由于过度潮湿地板超翘、膨胀或分层;
- The zygote, by cell division, grows into a morula an then into a blastocyst. 通过细胞分裂，受精卵发育成桑葚胚，然后发育成囊胚。
- Morula is rich in nutrient components and has a high value of utilization. 桑椹营养物质含量丰富，利用价值高，在食品和医药保健方面开发前景广阔。
- In composite laminates there are four basic failure modes: matrix cracking, delamination, fiber breakage and debonding. 复合材料层合板中存在四种基本的失效模式，即：基体开裂、分层、纤维断裂及脱粘。
- Mechanisms of delamination, void defects in electroless plating and nonuniformity in electroplate were introduced. 重点介绍了钻孔中分层、化学镀铜中的气泡缺陷、电镀中的镀层不均匀等缺陷产生的机理。
- The term "morula" refers to the fertilized egg before it begins its cell division. “桑椹胚”定义为开始细胞分裂之前的受精卵。
- The result indicates that the load for delamination initiation is increased with the increase of the runout length. 结果表明，增加筋条斜削区长度可以延缓脱层的起始。
- The influence of laminate thickness,delamination location and size on compressive strength was discussed. 得出如下结果:厚板对分层缺陷不敏感,中等厚度和薄层合板比较敏感;
- After that, the DNA methy-lation levels of the fused embryos are gradually increased until the morula stage. 随着胚胎继续分裂, 胚胎甲基化水平逐渐增加, 在桑葚胚期甲基化水平最高;
- And drilling CFRP with UVD, the delamination is reduced and the hole quality is improved. 应用这种 方法钻削复合材料，可以减小材料的分层，提高加工质量。
- Because of stress concentration, coating surface suffered micropit failure and deep delamination. 由于应力集中，涂层表面发生微观点蚀和深层剥落；
- The additional state of axisymmetric delamination problem of sandwich plates is studied. 研究了夹芯板轴对称脱层问题的附加状态.
- The test indicates that the hole is unruffled and that the delamination, napping and breakup can be avoided. 试验结果表明：孔口平整，有效避免了构件材料的分层、拉毛和崩豁等加工缺陷。
- Then these 1-cell embryo,2-cell embryo,morula and blastocyst were respectively transferred into the oviduct and the uterus of pseudopregnancy KM mouse. 结果移入1-细胞胚、2-细胞胚、桑椹胚和囊胚的假孕母鼠妊娠率分别为36.;36%25、42
- The delamination crack has certain direction, and the number of the delamination crac... 随着试验温度增高,分层裂纹对材料的力学性能影响增大。
