您要查找的是不是:
- maximum voltage relay 过压继电器
- When evaluating either maximum voltage or maximum current levels, the power rating of the relay must also be considered if the specified life is to be attained. 在评估最大电压或最大电流水平时,要想达到规定的寿命,则必须考虑继电器的功率额定值。
- When voltage become over the setting value, voltage relay shall be operated. 当电压成为超过设定值,电压继电器应经营。
- The maximum voltage developed across an input diode with test current applied. 测试电流加到输入二极管所产生的最大压降。
- The nominal full load voltage and maximum voltage have been computed. 这样就可以计算出满负电压值和最大电压值。
- Automatic feedwater and constant temperature were realized by low voltage relay. 在电路上采用低电压温控继电器安全设计,实现了自动给水和加恒温控制;
- This is the maximum voltage that can be applied safely to an output terminal, with respect to the ground of the device. 这是能安全地作用于输出端的、相对于器件地的最大电压。
- TI ? The maximum voltage developed across an input diode with test current applied. 测试电流加到输入二极管所产生的最大压降。
- VOH is the absolute maximum voltage level with respect to VDD (drain-to-drain voltage) that the output can reach. VOH为相对于输出所能达到VDD的绝对电压最大值。
- When you drive the output high, VH is the maximum voltage level at the output in the dc-open-loop-gain measurement. 驱动输出为高时,VH为输出直流开环增益测量的最大电压。
- Max external voltage: Maximum voltage to be continuously given to component in the dark. 最大外加电压在黑暗中可连续施加给元件的最大电压。
- The hardware of the voltage relay are divided into five parts, which are central processing unit, A/D conversion, keyboard display, communication module and execution module. 文中在硬件设计部分将该继电器分为中央处理单元、模数转换模块、键盘显示模块、通信模块和执行模块等几部分进行了详细的论述。
- The 1 372s FUDS test results show that the maximum voltage error of these two models are 1.02% and 1.39% of battery pack ... 通过1 372 s的FUDS实验验证;两个模型最大电压误差分别为电池组额定电压的1.;02%25和1
- This is the maximum voltage required to be driven by the FPGA so that it can still detect a valid logic low state (the max VIL value). 这是FPGA驱动该器件需要的最大电压,所以该设备仍然可以检测到一个有效的逻辑低状态(最大VIL值)。
- The 1 372s FUDS test results show that the maximum voltage error of these two models are 1.02% and 1.39% of battery pack rated voltage respectively,meeting the accuracy requirements of electric vehicle simulation. 通过1 372 s的FUDS实验验证;两个模型最大电压误差分别为电池组额定电压的1.;02%25和1
- This study investigates electrical transient responses of a piezoelectric transducer and their major characteristics such as maximum voltage, minimum voltage and peak-to-peak voltage under impact. 摘要本文探讨压电换能器受到冲击时之暂态电压响应及其主要特性。此特性涵盖暂态期间的最大电压、最小电压及峰对峰电压。
- Be careful when connecting a voltage or current source to your DAQ device.Make sure the signal source will not exceed the maximum voltage or current that the DAQ device can handle. 在DAQ设备与电压源或电流源连接时必须细心,以确保信号源不超过设备所允许的电压或电流最高值。
- If the meter is switched to 20 V DC, for example, then 20 V is the maximum voltage which can be measured, This is sometimes called 20 V fsd, where fsd is short for full scale deflection. 例如,如果仪表切换到DC20V档,那个20V就是此档可以测量的最大测量电压,这可以称为20VFSD,FSD为满量程值的缩写。
- induction type under voltage relay 感应式过低电压继电器
- positive-phase-sequence voltage relay 正相序电压继电器