您要查找的是不是：
- Dimensional Analysis Application in the Study of Main Pressure Loss of Circulating Fluidized Bed 因次分析法在研究循环流化床主压降中的应用
- main pressure loss 主压降
- Enter 0 for main pressure tolerance plus. 主压力正公差输入0。
- It can not require a pressure loss. 它不会造成压力损失。
- Activate the individual selection main pressure. 激活单个选择的主压力。
- Note the current main pressure actual value. 记录当前主压力的实际值。
- Enter 50% for main pressure tolerance plus and tolerance minus. 主压力正负公差输入为50%25
- Select "with filling" at the main pressure regulation. 选择“物料”调节主压力。
- The thesis introduces the choose of the ejector, and it also shows you the design calculation and the choose of main parameters, including the pressure loss. 同时计算了压强损失,为集中式排种系统中风机的全压计算提供了数据参考。
- Note the set value for compaction force main pressure. 记录主压力设定值。
- Type 0- Full round port opening offering minimum pressure loss conditions. 类型0-全圆形端口开启度,压降损失最小。
- The tradeoff comes in how much permanent pressure loss can be tolerated. 平衡点在于究竟容许多少长期压力损耗。
- Propeller meters introduce small pressure losses. 螺旋浆式流量计的压力损失
- Formation fluid migration after cementing as hydraulic pressure loss due to cement slurry shrinkage and gelatinization weightlessness is the one of main causes to effect cementing quality. 注完水泥后因水泥浆体积收缩和胶凝产生失重导致地层流体窜流仍然是影响固井质量重要原因之一。
- Direct connection to mains pressure water supply is not permitted. 严禁直接连在有压力的供水装置上。
- The results show that the A-t curve wave separator has a higher separation efficiency with a petty pressure loss. 结果表明,本文提出的A-t双参数曲线波形板分离叶片不仅分离效率高,而且流动损失小。
- The truss structure featured by small flow resistance,strong toughness and less pressure loss. 具有流阻小，刚性好，压力损失小的桁架式结构。
- Thus it was demonstrated that the main pressure zone was little affected by the downstream flow condition. 由此可见，下游的流动情况对主要压力区几乎没有影响。
- EP-W203/H DRA is a ultra-high molecular polymer, which can reduce the pressure loss of pipe flow. 型减阻剂是一种超高分子聚合物,注入管道后可以降低管流的压力损失。
- The punch diagram displays that the increased compaction force main pressure will be regulated to the set value. 冲杆图表显示主压力增加校准设定值。
