您要查找的是不是:
- The formation of "low pressure closed circumfluence region" and the entrainment of vortexes are the main reasons for vectoring a low speed jet. 压强梯度的存在和旋涡的卷吸作用是合成射流激励器控制宏观低速流流动方向的主要因素。
- DOES THE WIPER MOTOR OPERATE IN LOW SPEED? 雨刷马达在低速运转吗?
- Katajainen had to take off at too low speed. 卡塔雅南不得不以很低的速度起飞。
- Based on this computing model, numerical computations were performed for a low speed primary jet vectored using different synthetic jet actuators. 对合成射流激励器在不同工作状态下控制宏观低速流流动进行了数值分析和机理探讨。
- Sprinkle the yeast and sugar over the water and mix at low speed. 往水里撒上酵母和糖,用慢速搅拌。
- The analysis shows that the impingement caused by the high speed jet is the main reason of sporoderm broken. 分析结果表明:高速射流引起的撞击是造成灵芝孢子破壁的最主要原因。
- Population: The aggregate population of Beijing grew at low speed. 人口:全市人口总量低速增长。
- The SL-II's low speed handling was also a welcome surprise. 在下午二-二的低速处理也是一个惊喜。
- Add drained raisins. Knead for another 3 minutes at low speed. 加入滤干水分的提子,低速搅拌3分钟,直到完全拌匀。
- The high speed jet flow thus formed, guided by the rotating nozzel, scours repeatedly on the tank bottom at an angle of 3. 为防止原油储罐中沉淀物沉积,国外一些公司采用了皮托管射流器系统进行清渣除淤工作。
- The result shows that the synthetic jet actuator with an inclination angle can effectively control low speed primary jet vector and the primary jet direction can be changed greatly by altering the angle without increasing input power. 结果显示,激励器出口倾角对主流矢量角控制影响很大,在不增加输入功率的情况下,可使主流流动方向发生大幅度偏转。
- In a blender, mix all ingredients together on a low speed for 30 seconds. 将所有原料倒入掺和器中,慢速搅拌30秒。
- Population: The aggregate population of Beijing grew at a low speed. 人口: 全市人口总量低速增长。
- Add black sesame seeds and knead for another 2 minutes at low speed. 加入黑芝麻,低速继续拌均匀大约2分钟。
- The ideal method is low speed centrifugalization and dilution medium. 理想的方法是用低速离心加培养基稀释法。
- But low speed dawdling is not at all what this bike is about, is it? 但低速顸,是不是这回事,这是自行车约,是吗?
- The point we raised is that we need a new lower speed limit. 提出的要点是我们需要一个新的较低的速限。
- Setting very low speeds in a wind tunnel is always a vexatious problem. 在风洞中调出低风速来始终是一个麻烦问题。
- high speed jet electrodeposition 高速电喷镀
- Make sure you keep within the new lower speed limit. 一定要保持在新的较低限度内行驶。