您要查找的是不是:
- Results show the microstructure of IF steel,which exhibits excellent deep draw behavior and low anisotropy is relatively fine after low temperature annealing. 结果表明,低温退火的IF钢金相组织相对细致均匀,在拥有非常优秀的深冲性能的同时,亦具有相对较低的平面各向异性。
- In chapter 3, growth models for DC anodization of silicon are introduced.The ultra-thin gate oxides were prepared by anodization in H2O followed by low temperature annealing on new and recycle wafers. 第三章我们先介绍直流阳极氧化的成长机制,我们将以阳极氧化的方法在纯水中成长超薄闸极氧化层,在以低温热退火处理对于新与旧的矽晶圆作探讨。
- The results show that the aluminum foils cold rolled or low temperature annealed have not obvious anisotropy,tensile strength and elongation change a little after low temperature annealing. 结果表明,冷轧及低温退火后铝箔的力学性能均无明显的各向异性,低温退火时,抗拉强度和伸长率变化很小。
- The food should be kept at low temperature. 这种食品应低温保存。
- Lead will fuse at quite a low temperature. 铅会在相当低的温度下熔化。
- low temperature annealing 低温退火
- Lead fuses at a low temperature. 铅在低温下就熔化。
- The low temperature froze my flowers. 低温把我的花冻死了。
- Lead will fuse at a relatively low temperature. 铅不需要太高温度即能溶化。
- The low temperature will freeze my flowers. 低温会把我的花冻死。
- At a low temperature, water turns into ice. 水在低温时就结成冰。
- The mechanism of the degeneration of GMR effect in the sandwiches after high temperature annealing ... 还分析了三明治膜经高温热退火后巨磁电阻效应退化的物理机制。
- Water freezes at a low temperature. 水在低温时结冰。
- Finally, GOI fabrication is more suitability for low temperature splitting annealing. 最后,我们发现低温热退火更适合应用在绝缘层上锗制程。
- High temperature annealing of the pickled sample, followed by secondary pickling desorption, has been attempted for further refining. 并尝试在此后进行高温退火以再次造成表面扩散偏聚,然后继以二次酸洗去吸附除杂。
- Alignment requires low temperature. 取向排列需要低温。
- After high temperature annealing, the nanodots are polycrystalline and consist of a mixed phase of anatase and rutile instead of single rutile phase. 此外,研究结果显示氧化钛奈米点之相变化行为与一般氧化钛薄膜或粉末大异其趣。
- The local or general use of low temperatures in medical therapy. 冷疗法一种在医疗中局部或全部使用低温的方法
- The land itself freezes (up) in such low temperatures. 温度这麽低,地都冻硬了。
- This article introduces the state of installation and commissioning of an imported high temperature annealing furnace of mesh belt type and methanol cracking atmosphere. 介绍一台引进的采用甲醇裂解气的网带式高温退火炉的安装、试情况。