您要查找的是不是:
- My load at work has been getting heavier recently. 最近我的工作量在不断加大。
- load at rupture 破坏荷载
- Too many deployed activations are attempting to load at once. 一次尝试加载的已部署激活太多。
- Based on production experience this article analyzed the process factors affecting the elongation at rupture of HDPE resin and introduoes measures for improvement therefor. 结合生产实际,分析了影响HDPE树脂断裂伸长率的工艺因素,论述了提高HDPE树脂断裂伸长率的有效措施。
- If the module cannot load at its preferred base address, it cannot load at all. 如果模块不能加载到它的首选基地址,那么它就根本无法加载。
- A gun or other firearm loaded at the breech. 后膛枪,后膛炮在后膛装弹药的枪或其它火器
- C=Safe concemtrated load at vertical flat-steel direction in KN/m width. 加在正交于扁钢方向(垂直方向)上的安全外加线载荷,用千牛顿、米宽表示。
- The document begins loading at this point. 文档在此时开始加载。
- Bile salts are unusually effective at rupturing cell walls. 胆汁酸盐对于破坏细胞壁通常很有效。
- We shall be glad to make you special offer for order of not less than a truck load at a time. 如一次订货超过一卡车以上,我们将给与特别优惠价。
- The ratio of output power to input power expressed as a percentage. This is generally measured under full load at nominal line voltage. 输出功率与输入功率之比的百分数。通常是在满负荷额定线电压下测定的。
- The analysis of these curves leads to a conclusion that the material damage at rupture is monotonically decreasing function of applied stress. 对这些曲线的分析导致结论:材料破坏时的损伤是所加应力的递减函数。
- Which contains the path of the file to be loaded at run time. 该变量包含要在运行时加载的文件的路径。
- Are full containers loaded at factory for limited brands? 是否所有在工厂装货的集装箱有限制商标?
- Shipper is to pack the container in full load at his plant or at his place of business. 托运人则在其工厂或业务场所进行整箱装箱。
- Doing so will result in a build warning, and the application will fail to load at run time. 这样做将导致生成警告,运行时应用程序将无法加载。
- As the load weight changes, the either raises or lowers, keeping the top of load at a convenient height. 可随承载重量的变动,台面自动上升或下降,保持人体工学上方便作业高度,达到省力,避免工作伤害之创新机型。
- The load at each bearing point is the sum of the two distributed load on two ends. 3每个支吊点的荷载为前后两跨段所分配荷载之和。
- In such circumstances, the FCA term should be used, provided the seller agrees that he will load at his cost and risk. 由于公司在约定日期无法租到合适的船,且买方不同意更换条件,以致延误了装运期,买方以此为由提出撤销合同。问:买方的要求是否合理?
- The acting form of the load at the joint of the bridge is discussed through a photoelasticity experiment. 通过光 弹性实验,分析机器人桥架连接处的受力形式。