您要查找的是不是：
- Link Status Signal Units (LSSU) - transport link status information to an adjacent signaling point. 链路状态信令单元 (LSSU) -- 将链路状态信息传输到某个相邻的信令点。
- LSSU (Link Status Signaling Unit)last bit of previous unit lssu(链接状态信令单元)前一个单元的最后一位
- LSSU Link Status Signal Unit 链路状态信令单元
- Link status signal unit LT 链路状态信号单元
- link status signal unit 链路状况信号单元
- Link Status Signal 链路状态信号
- Signal unit initial alignment - invokes initial alignment prior to activating or restoring a signaling link. 信令单元初始定位 -- 在激活或恢复信令链路之前调用初始定位。
- This detector provides status signal of material flow in bulk conveying system. 物料探测器提供散料输送系统中物料流动状况信号。
- Signal unit delimitation - inserts binary flags?to delimit (separate) messages. 信令单元定界 -- 插入二进制的"标志"定界(分隔)消息。
- OSPF gathers information from neighbor routers about the link status of each OSPF router. OSPF收集从邻近路由器来的关于每个OSPF路由器的链结状况的资讯。
- There are three different types of signal units differentiated by the value contained in the Link Indicator field. 有三种不同的信令单元链路，可根据指示器字段所含的值进行区分。
- Sufficient status signal shall be identified, verified and monitored to apply the rejection criteria. 鉴别、确认和监测足够的状态信号,以便确定数据剔除规则。
- These signal units are used to bring a link up or down and verify that it is working correctly. 这些信令单元用于建立或撤消某个链路并验证链路是否正常工作。
- MTP Level 2 messages are placed into the MTP Level 2 signal units for transport across the link. MTP 第2级的消息会放置在MTP 第2级的"信令单元"中以便在链路上传输。
- Signal unit error detection and correction - discards detected erroneous message and requests a re-transmission. 信令单元错误检测和校正 -- 废弃检测到的出错消息并请求重新传输。
- Trainees are drawn from infantry, engineers, and signal units. 士兵都是从步兵、工兵和通信兵里面选拔。
- Signal unit delimitation - inserts binary 襢lags?to delimit (separate) messages. 信令单元定界--插入二进制的"标志"定界(分隔)消息。
- Reactions to link status notification callbacks from underlying protocol services (SMTP and MTA) due to an interference on the X.400 or SMTP protocol levels by non-Microsoft applications. 由于非Microsoft应用程序在X.;400或SMTP协议级别所引起的干扰;导致从底层的协议服务(SMTP和MTA)回调链接状态通知响应。
- MTP Level 2 messages are placed into the MTP Level 2 signal units?for transport across the link. MTP 第 2 级的消息会放置在 MTP 第 2 级的"信令单元"中以便在链路上传输。
- ODMRP protocol is an on-demand multicast routing protocol in Ad hoc network.. This paper presents the On-Demand Multicast Routing Protocol with Link Status Forecasting (LSF-ODMRP ). 摘要 ODMRP协议是无线自组网环境下的一种按需式组播路由协议。
