您要查找的是不是:
- LSSC Line Signal Sender Connector 线路信号发送器链接口
- line signal sender connector 线路信号发送连接器
- A line signal sent forward to indicate that address signals are about to is transmitted. 一种转发的线路信号,用来表示地址信号即将被传输。
- line signal sender 线路信号发送器
- A Receive connector can only be linked to one Send connector. 接收连接器只能链接到一个发送连接器上。
- Send connector %1 has failed to authenticate with %2. 发送连接器%251使用%252进行身份验证失败。
- Configure this Send connector to use a smart host for routing e-mail. 将此发送连接器配置为使用智能主机路由电子邮件。
- You must configure at least one Send connector to establish Internet mail flow. 必须配置至少一个发送连接器以建立Internet邮件流。
- The shorting together of wires in a connector so that a signal sent along the wire returns to its place of origin. 相邻的线路[通常为两蕊]构成一个讯号传输出去及讯号取回之路径即称为迴路。
- Physical failures are indicated by loss of line signals. 物理失效是由丢失行信号来表示的。
- All the planes could jam the high-powered signal sent by radar. 这些飞机都能干扰雷达发出的大功率信号。
- A signal sent to dynamic RAM to maintain its storage contents. 送给计算机动态随机存储器的一种信号,以维持其存储的内容。参阅CRT,dynamicRAM。
- Reenter the username and password on the specified Send connector and at the remote server. 在指定的发送连接器和远程服务器上,重新输入用户名和密码。
- The signal sent out, “this is the mighty Missouri, starboard. 信号发出去:"这里是密苏里巨轮,请右偏。"
- An authentication credential initialization error %1 occurred with Send connector %2. 发送连接器%252初始化身份验证凭据时出现错误%251。
- "This is tantamount to a market open to the signal sent to. 这等于是向市场公开发出了求地的信号。
- An implicit Send connector from the Hub Transport servers that are in the same forest to the Edge Transport server. 从同一个林中的集线器传输服务器到边缘传输服务器的隐式发送连接器。
- In telephony, a signal used by a telephone operator to gain the attention of another, or a signal sent by a subscriber held by an operator to gain the latter's attention. 在电话技术中,电话操作员使用的一种信号,用来获得另一次注意,或由操作员保持的用户发送的一种信号,用以获得随后的注意。
- You can use the Get-AdPermission cmdlet to view the DACL for a Send connector or a Receive connector. 可以使用Get-AdPermission cmdlet查看发送连接器或接收连接器的DACL。
- To configure the Send connector to use authentication, you must first run the Get-Credential command and assign it to a variable. 若要将发送连接器配置为使用身份验证,必须首先运行Get-Credential命令,并将该命令赋予一个变量。