您要查找的是不是:
- limit shear strength 极限剪切强度
- Touch and close fasteners - Determination of longitudinal shear strength. 粘接拉链。纵向剪切强度的测定。
- The results show that the shear strength of COF is higher than that of COG. 结果表明 :COF比 COG的剪切强度高 .
- The shear strength of the composite is improved above to 11 MPa from 5.5MPa. 改性后碳 /聚芳基乙炔复合材料的剪切强度由 5 5MPa提高到 11MPa以上
- The shear strength of COG and COF bonded with ACF is studied by impact test. 摘要采用冲击试验方法研究了各向异性导电胶膜(ACF)互连的玻璃和柔性基板上倒装芯片(COG和COF)的剪切结合强度。
- The adhesive should preferably have a shear strength greater than 30 mpa . 粘结膜最好具有大于30毫帕的剪切强度。
- The result shows that the plasticity index and the compression coefficient of the northern inshore saline soil reduce with the increase of the salt content, and the shear strength attains a limit value with the increase of the salt content. 结果表明,北方滨海地区盐渍土的塑性指标、压缩系数随含盐量的增加而降低,抗剪强度随含盐量增加出现一含盐量界限值。
- Indirect methods to measure the interface bond strength include the interlaminar shear strength test. 测量界面粘结强度的间接方法包括层间剪切强度试验。
- Ambitious attempts to improve interlaminar shear strength have been made by Mueller Prosen and by Keogh. 米勒·普罗森还有基奥都对提高层间切变强度作了大胆的尝试。
- Variation Rule of Shear Strength Index When Direct Shear Test of Coarse-grained Soil. 粗粒土直接剪切试验抗剪强度指标变化规律。
- Embedded columns can increase shear strength as well as control of displacement and failure. 配以暗框边柱能提高剪力墙的抗剪强度、位移控制和破坏控制能力。
- The wood is moderately hard and strong with high bending strength, shear strength and stiffness. 这类木材硬度适中而强壮,具有高度弯曲力、剪力和硬度。
- The melting point and the shear strength of Bi-Pb-Sn-Cd fusible alloys were determined by DSC and tension tester. 利用差热分析仪和拉伸试验机;研究了易熔合金Bi-Pb-Sn-Cd的成分对合金熔点和剪切强度的影响.
- The observed inlet dimple can be tentatively interpreted by limiting shear stress or wall slippage. 润滑油的极限剪应力特性及其诱发的界面滑移为凹陷产生的原因。
- Besides, the undrained shear strength was increased slightly due to the negative pore pressure. 不排水条件下由于负孔隙水压力的存在,土样的表观强度略有增大。
- The results showed that the shear strength of epoxy bonded joint decreased after it was aged in acid media. 结果表明,环氧胶接接头在酸性介质中老化后,其剪切强度明显降低;
- The results showed that the shear strength of fractal joints decreases nonlinearly as the filling percentage increased. 结果表明,随着充填度的增大,分形节理抗剪强度总体上呈非线性减小。
- Classical soil mechanics doesn't consider the influence of the matric suction in unsaturated soils on shear strength. 摘要:传统土壤力学并未考虑不饱和土壤中基质吸力对剪力强度之影响。
- Clinical Releance: Optimizing axial stability and limiting shear instability appear to be important for creating conditions for timely fracture-healing. 临床关联:轴向稳定性的优化和限制剪切不稳定的出现对适时的骨折愈合创造条件重要。
- HY/PA can improve not only the transverse shear strength of CF/PA but also the longitudinal shear strength of KF/PA. 另外,HY/PA在改善CF/PA的横向剪切强度的同时,也改善了芳纶纤维增强尼龙复合材料(KF/PA)的纵向剪切强度;