您要查找的是不是：
- Keywords Agglomeration;Latex;Multi-stage emulsion;Polymerization;Latex particle diameter;Latex particle distribution;Agglomerating peak;Agglomerating pattern.; 附聚;胶乳;多步乳液聚合;乳胶粒直径;乳胶粒分布;附聚峰;附聚规律;
- latex particle diameter 胶乳粒径
- It is widely recognized that ,in such cases, the particle diameter of rubber (PB latex or SBR latex) greatly governs the impact resistance and processability of the final products. 我们知道聚丁二烯(PB)胶乳或丁苯(SBR)胶乳的橡胶粒径是控制最终产品抗冲性能和加工性能的重要指标。
- Lime slaking rate is decreasing with lime particle diameter. 消化速率随着石灰粒径的减小而明显增大;
- The hydrolytic reaction,crosslinking reaction and latex particle structural morphology were characterized by IR and TEM. 以红外光谱、透射电子显微镜表征水解反应、交联反应及乳胶粒结构形态。
- With methyl methacrylate the particle diameter increases linearly with conversion indicating particle aggregation. 采用甲基丙烯酸甲酯时，粒子直径随转化率呈直线增大，这就表明粒子发生了聚集。
- The result gave the optimal filter particle diameter, layer thickness and filtration velocity. 根据实验结果，确定了最佳的过滤介质粒径、过滤层厚度和过滤速度。
- The influence of agitation intensity and agitator types on size of latex particle, polymerization rate, and latex stability during emulsion polymerization is reviewed. 综述了乳液聚合过程中搅拌强度对乳胶粒径、聚合反应速率、乳液稳定性的影响及搅拌器形式的影响。
- The sizes of the latex particles are investigated by TEM. 利用TEM观察了乳胶粒子大小及规则程度。
- In additional, influence of heating rate and particle diameter on combusting process is studied. 研究了升温速率、粒径对燃烧过程的影响,并计算出废轮胎燃烧动力学参数,获得其燃烧反应机理。
- To prepare clindamycin phosphate liposome, and to determine the entrapment efficiency and particle diameter of it. 目的制备克林霉素磷酸酯脂质体并测定包封率及粒径。
- The preparation in osmotic swelling and the application performances of hollow latex particle in electrophoretic display ware mainly discussed in this study. 本文研究的主要内容为以渗透溶涨法制备中空乳胶粒子,并研究其在电泳显示方面的应用性能。
- With small particle diameter of these packings, it was advantageous to separate and analyze large biomolecules. 此填料粒径小,有利于蛋白质生物大分子的高效快速分离分析。
- The smaller the latex particle size (Ps), the higher the dry, and wet pickings and paper gloss ;to acquire better opacity, larger particle size must be chosen. 小粒径者光泽度和乾、湿强皆佳，要有良好不透明度则需要大粒径之乳胶。
- The influences of jetting gas velocity and particle diameter on fluidization were analyzed. 分析了风管小孔风速和颗粒直径对床内流化的影响。
- The design of MSF microlatex filler for soft leather was reviewed in this paper. It is contained the design of molecule and latex particle, the selection of additives, etc. 论述了MSF微胶乳型软革填充树脂的设计问题，包括粒子设计、分子设计和助剂搭配等。
- For granular coke, the contact resistances have relations to the granular size or particle diameter, th... 接触电阻"则与焦炭颗粒的大小、形状、颗粒分布以及所处的压力状态等因素有关。
- The design of MSF microlatex filler for soft leather was reviewed in this paper,which contained the design of molecule and latex particle, the selection of additives, etc. 论述了MSF微胶乳型软革填充树脂的设计问题，包括粒子设计、分子设计和助剂搭配等。
- Knowledge of the particle diameter and fluid properties immediately defines the region of flow and the applicable relations. 已知颗粒直径和流体性质，就可直接确定流动区域和适用的关系式。
- And according to data of rheological experiments, zero shear viscosity of latex systems of polymethylmethacrylate in different particle diameters was obtained. 同时依据实验数据,得到了不同粒径聚甲基丙烯酸甲酯乳胶粒子体系的零切粘度值。
