您要查找的是不是：
- latent heat per mol 每克分子潜热
- latent heat per mole 每克分子潜热
- The amount of heat per mole necessary to cause the rise of temperature is different in each case. 在每一种情况下，致使每一摩尔物质升高温度单位所需要的热量是不相同的。
- latent heat per gram 每克潜热
- There is one proton,or equivalent,per mole of KHP. 每摩尔的KHP含等量的H离子数。
- A similar definition holds good for latent heat of vaporization. 气化潜热的定义与此雷同。
- It releases more heat per unit of weight than any other fuel. 作为燃料,它每单位重量释放热量最多。
- Ionization Energy (IE) and Electron Affinities (EA) are expressed as kilojoules per mole. 电离能和电子亲和性表达为每千焦耳摩尔。
- The half-year cycle of latent heat flux exists in the Xisha area, with the maximum appearing in winter. 西沙海面潜热通量存在半年周期特征，极大值也是出现在冬半年。
- The cooling system has to remove about 60,000 BTU of heat per minute. 冷却系统必须每分钟带走大约6000英国热量单位的热量。
- In this case latent heating and radiation cooling are comparable. 在这种场合，潜热加热和辐射冷却数值相当。
- The Effect of Latent Heat Release on the Evolution of a Warm Occluded Thermal Structure. 潜热释放对热固囚热结构的作用。
- The results show that vorticity advection, thermal advection and latent heat release made great contribution to the development of the depression. 中低层的温度平流、降水凝结释放潜热维持上升运动，是低压进一步发展的有利条件。
- Specific luminescence activity of the labeled antibody is l. SxlO1 cps/mol with an average incorporation ratio of 2.4 mole of DMAE-NHS per mole of antibody. DMAE·NHS与抗体偶联物DMAE·NHS-Ab的发光性能与DMAE·NHS相似，DMAE·NHS与Ab的分子比为2.;4时其发光强度为1
- Heat arriving at the interface is immediately converted to latent heat of vaporization (the water boils). 到达接口的热立刻被转换成潜在汽化热(水煮沸)。
- The specific latent heat is the difference in enthalpies of the substance in its two states. 比潜热是物质在两种状态下的焓差。
- The low-temperature blown gas discharged from the fixed-bed intermittent gasifier contains high latent heat. 固定层间歇式煤气发生炉排放的低温吹风气具有较高的潜热。
- The catalytic activity of resin 732 is higher than D72 when the molar ratio of acetic acid and butanol is 1 : 1 . 2 and catalyst is 35g per mol acetic acid. And the selectivity, stability and lifetime of resin 732 were more superior. 在醋酸与丁醇的摩尔比为1：1.;2和催化剂加入量为36克/mol醋酸的情况下，732树脂显示了高的催化活性和好的选择性，且催化活性稳定，使用寿命长，是较好的液固相酯化催化剂之一。
- Thermal energy storage are the technologies that make use of latent heat stored by Phase Change Materials (PCMs). 蓄热技术利用相变材料（Phase Change Material，PCM）的相变热来储存热能。
- The results show that melting latent heat of the cool storage material is 149kJ/kg, phase change tempera. 通过实验方法研究了空调蓄冷材料的相变温度、相变潜热和比热等热学性能。
