您要查找的是不是：
- intergranular cavitation 粒间空穴
- Cavitation can be caused by a variety of reasons. 气穴可以由各种原因引起。
- Cavitation is noisy and easily detected by sonar. 空泡现象是有噪声的并且容易被声纳探测到。
- It explores the most conditions of cavitation. 探索了最优空化强化条件。
- Areas of necrosis and cavitation may occur within the tumor. 肿瘤内可以有坏死和成腔区。
- This is the basis of the phenomenon called cavitation. 这就是所谓汽蚀现象的根据。
- The total diameter of cavitation, if present, is less than 4cm. 若出现空洞，其直径总和小于4厘米。
- Excessive noise is an indication that cavitation is occurring. 噪音太大是发生空洞现象的一个征兆。
- This type of corrosion can be the starting point for intergranular corrosion. 此类锈蚀腐蚀会成为晶粒间锈蚀腐蚀的开端。
- Flow metering installation shall not cause flashing or cavitation. 流量表的安装不应引起闪蒸或气蚀。
- Cavitation damage was uneven and cavities appeared in local places. 空蚀破坏呈现不均匀性,局部区域出现大的空蚀坑。
- This is the basis of the phenomenon called cavitation . 这就是所谓汽蚀现象的根据。
- For intergranular materials, poorly to moderately well cemented, the total porosity is approximately equal to the effective porosity. 对于由晶体构成的物质，其晶粒间含泥浆少或较少，因此总孔隙度与有效孔隙度近似相等。
- For non-compressible fluids, where pressure drop causes cavitation or flashing. 对于不可压缩性流体,如果压降产生空穴或闪蒸。
- Excessive fluid noise is usually an indication that cavitation is occurring. 如果流体噪音过大,则通常意味着出现气穴现象。
- Intergranular stress corrosion cracking behavior of austenitic steels on hydrogenated high-temperature. 奥氏体钢在高温氢化物中的晶间应力腐蚀开裂性能。
- In both silicosis and CWP, these masses can undergo necrosis and cavitation. 无论硅肺还是CWP的大结节团块都可以出现坏死和空洞。
- The composite displays the fracture features of the dimple and intergranular fracture. 复合材料的断裂形貌为韧窝加沿晶断裂。
- Extremely high velocities should be avoided due to possible cavitation. 应该避免应用在可能出现空穴现象的流速异常高速的场合。
- The quench sensitivity relative to intergranular corrosion increased with the increase of rolling deformation. 随着轧制变形量的增大，合金晶间腐蚀的淬火敏感性增大。
