您要查找的是不是：
- High fracture toughness and insulation resistance. 高断裂强度及绝缘性能。
- Measuring insulation resistance for circuit. 电路绝缘电阻测量。
- To measure the hot insulation resistance. 热态绝缘测量。
- The insulation resistance is too low. 绝缘电阻太低。
- High break down voltage and insulation resistance. 高耐压及绝缘性能。
- Shall we start the testing of cold insulation resistance? 冷态绝缘电阻测试是否可以开始?
- The temperature characteristics of insulation resistance of capacitor covers. 电容器盖板绝缘电阻的温度特性。
- The insulation resistance of a cable is inversely proportional to its length. 电缆的绝缘电阻与其长度成反比。
- Inspection installation for antenna of radio console and measuring its insulation resistance. 组装报务台天线安装检查和绝缘测量。
- Features: Low dissipation, high insulation resistance, good capacitance stability. 特点：损耗低，绝缘电阻高，容量稳定性好。
- Measuring insulation resistance and reliability test protection device for main switchboard(emergency switchboard). 总配电板(应急配电板)绝缘电阻测量和保护装置可靠性试验。
- This section describes surface insulation resistance measurements using the Model 6517A Electrometer/Voltage Source. 本节介绍使用6517A静电计电压源测量表面绝缘电阻的情况。
- When measuring high resistance, the insulation resistance of the cable is important. 在测量高电阻时，电缆的绝缘电阻是很重要的。
- And shake the electrical insulation resistance measurement, and its value is not lower than 50 megohm. 然后摇测电机的绝缘电阻，其值不低与50兆欧。
- The reason that the insulation resistance becomes low for the ZnO arrester s base support is briefly analyzed. 简要分析了氧化锌避雷器底座支持小瓷瓶绝缘电阻下降的产生原因,并介绍了一种简便的处理方法。
- The insulation resistance is the combination of R1-2 and R1-3 in parallel as shown. 如图所示，绝缘电阻将是电阻R1-2和R1-3并联形成的电阻。
- Measure the insulation resistance of cable to ground or iron shielded layer and cores. 测量电缆对地或对金属屏蔽层间和各线芯间的绝缘电阻.
- Creped insulating paper for transformer, in rolls or sheets (insulation resistivity over 1000000000 ohm), other than paper of the kind described in heading No. 48.03. 变压器用绉纹绝缘纸，卷筒或平版（绝缘阻抗1000000000欧姆以上），第4803节所述者除外
- You'd better put some insulating tape on electric wires. 你最好给电线裹上绝缘胶布。
- If the insulation resistance is under the numerical value required or the tie-in of the cable loosen or break off,the result will be noted. 如有绝缘电阻低于绝缘要求，或电缆接头松脱、断线，结果将被自动记录。
