您要查找的是不是:
- The input bias current flows at the instrument input due to internal instrument circuitry and the internal bias voltage. 仪器内部电路和内部的偏移电压会在仪器的输入端引起输入偏置电流。
- This module setup the output DC biasing voltage at VDD/2 whatever at different input biasing voltage. 放大器的共模反馈模块使得系统在不同的输入共模电平条件下输出信号偏置电压均稳定在VDD/2附近,并建立正常的系统直流工作点。
- Different bias voltage for the input buffer transistor. 不同偏置电压的输入缓冲晶体管.
- input bias voltage 输入偏置电压
- However, also consider amplifier noise, input bias current, offset voltage, MDAC resolution, and glitch energy. 然而,也要考虑放大器的噪声、输入偏置电流、偏置电压、MDAC分辨率和毛刺能量等因素。
- The full bias voltage appears across RL2. 全部的偏置电压出现在RL2上。
- The transformer isolates the transistors with regard to d-c bias voltage. 变压器可在两个晶体管之间隔离直流偏压。
- Another consideration when measuring voltages from high resistance sources is the input bias current of the voltmeter. 在测量高电阻源时要考虑的另一个问题是电压表的输入偏置电流。
- Picoammeters and SMUs also have very low input bias currents, although usually not as low as an electrometer's. 皮安计和SMU也具有很低的输入偏置电流,但是通常没有静电计低。
- One measure of the quality of a diode is its leakage current at a specified reverse bias voltage. 衡量二极管质量的一个方面就是在规定的反向偏置电压下的泄漏电流。
- The combination of low offsets, low noise, very low input bias currents, and high speed make these amplifiers useful in a wide variety of applications. 低失调、低噪声、极低的输入偏置电流和高速度特性相结合,使这些放大器适合各种应用。
- In the experiment, we found the locking range of OEO was greatly affected by the bias voltage of modulator in the loop. 实验中发现OEO中凋制器的偏置电压对OEO的注入锁定范围有很大影响.
- If the bias voltage is less than 42V off ground, the isolated BNC vacuum feedthrough will not need a safety shield. 如果对地的浮地电压小于42V,那么绝缘的BNC接头就不需要安全屏蔽。
- When JFET is used as a low-noise and high-operational amplifier in input tube, plate fond and back grid can be separated to decrease input bias and increase input impedance. 在JFET作输入管的低噪声高精度运放中,为了进一步减小输入偏流,增大输入阻抗,可使顶、背栅分离,且仅以顶栅接输入信号,而背栅接片内控制电路。
- The limiter consists of a superconducting coil, a diode bridge and a bias voltage supply. 桥式超导故障限流器,它由超导磁体、二极管桥路和直流偏压源组成。
- During IGBT is off, the gate should be provided reverse bias voltage for ensuring the safe of IGBT. 在IGBT关断期间,IGBT的栅极需加反向偏置电压,避免IGBT的误动作。
- How to choose the bias voltage, the width and the period of the gated pulse is very important. 偏置电压的大小、门脉冲宽度和周期的选择对后脉冲的消除起着关键的作用。
- The gain of the APD can be controlled by the magnitude of the reverse bias voltage. APD的增益可以由反向偏置电压的幅度来控制。反向偏置电压越大增益就越高。
- Input offset current is the difference between the two input bias currents and this leads to offset errors in in-amps when source resistances in the two input terminals are unequal. 输入失调电流是两个差动输入端的基极输入电流,当两个输入端的源阻抗不相等时,它可引起仪表放大器的失调误差。
- Reference [1] concluded that for the phase-locking of Gunn Oscillator, timing by varying the bias voltage on the diode is not a practical method. 以往国内外采用种种锁相方法,而直接控制体效应振荡器偏压的锁相法则被认为是不切实际的方法。