您要查找的是不是：
- inner c ase of stern tube 尾轴管的内套
- Flushing L.O.system of stern tube. 艉轴管滑油系统的投油清洗。
- The rubber bushing is suggested to be used when the lubricating medium of stern tube is water. 船舶艉管工作介质为水时，建议选用该橡胶轴承。
- Preparing work before tail shaft installation, the flushing oil and the integrity of stern tube should be delivered to ship-owner and surveyor. 艉轴的安装准备：艉轴末端的螺纹部分用布或薄橡胶皮包扎好，防止在装配中碰伤。首密封及其附件（如垫片等）应装上艉轴。
- By inner diameter micrometer, add technical screw to the both ends of the stern tube at point A、C in order to make them the base of boring rod alignment. 通过内径分厘卡的测量，将A、C两个点上的基准功能分别转往各个对应的工艺基准螺钉上去，使他们成为镗杆校中的依据。
- Measuring diameter of fore and aft stern tube bearing and bushes. 艉轴管前、轴承与衬套直径测量。
- Inner case of stern tube 艉轴套内壳
- Stern tube L.O. Gravity tank low level alarm. 艉轴管滑油重力柜低位报警。
- Hydraulic test for L.O. pipe for stern tube. 艉轴管滑油液压试验。
- Joint Location Lump, Fairing Cap, Shield, Flange in front of Stern Tube 齿联定位块、导流帽、艉管前法兰、防护罩及附件
- Inspection push-up load for fore and aft stern tube bushes. 艉轴管前、后衬套压入检查。
- ASE of dye medium in a DLA and fs pulse amplification[J]. 引用该论文 肖纲要;何慧娟;沈晋汇;刘玉璞;张影华;陆培华;王之江.
- WTH X C ASE REPORTAt first birth process, the midwife accompanied the lying-i n woman shifted to the delivery room and told her the ease pain and how to c ontr ol the labor step at the labor. [病例报告 ]在第一产程 ,产妇转入产室后由助产士陪伴 ,告知产妇分娩时的镇痛及应急措施 ;
- Haldeman was made of sterner stuff. 霍尔德曼的性格要更加坚强。
- Stern tube may be welded in between shaft boss and aft peak bulkhead. 可以对轴毂和艉尖舱壁之间的尾管进行焊接。
- Perhaps you are made of sterner stuff. 也许你是铁打的。
- Instruction for users of Stern Suspension Type Electric Propeller. 艉挂式电动推进器的使用说明书。
- Guard ring of stern tube 尾轴管防护环
- RZ, CSRZ and SSB-RZ have almost same tolerance to ASE of EDFA, but the three formats are more tolerant than NRZ in ASE of EDFA. RZ ,CSRZ和SSB RZ三种格式抗EDFA噪声能力差不多 ,但都比NRZ强
- The axial speed fie ld of impeller distributes uniformly, but the uniformity decreases as the incre ase of distance to impeller. 推进桨轴向速度流场均匀，但随着离桨距离的增加其均匀性下降，且轴线附近存在有低速区。
