您要查找的是不是：
- Reduce hydraulic control manifold pressure to 5200 kpa. 将液压控制管线压力减少到5200千帕。
- An expansion of unburnt gases in the exhaust system or a premature explosion in a cylinder or inlet manifold. 在排气系统未燃烧尽的气体的爆炸,或者在汽缸或进气管道的过早爆炸。
- In order to producte qualified inlet manifold casting, top gating system with lip riser and shell core made of precoated sand is used. 为了获得合格的进气歧管铸件，采用压边顶铸浇注系统和覆膜砂壳芯制作工艺。
- A new casting technology for inlet manifold in tilt casting machine for gravity die casting was described. 介绍了在可倾式金属型浇注机上制造进气歧管的铸造新工艺。
- Fault Description(reason): High voltage detected at intake manifold pressure sensor signal pin. 故障描述（原因）：检测到进气歧管压力传感器信号电压值高。
- This paper introduces the calibration system and static and dynamic calibration method of an engine intake manifold pressure sensor. 介绍了发动机进气歧管压力传感器的标定系统和传感器静、动态标定方法。
- Overpressure to the Inlet Manifold 进口多头导管超压
- With EGT strategy, the pumping loss is reduced due to the increase of intake manifold pressure, and the increase of intake temperature leads to the complete combustion and high combustion efficiency. 分析表明，废气滞留可以提高进气歧管压力，明显降低泵气损失；混合气温度提高促进燃烧更完全，使燃烧效率得以提高；
- It was not clear that Nixon retained enough authority to manage the manifold pressures about to descend him. 尼克松是否还保持着足够的权威来对付即将降临到他头上的多方面的压力，还很不清楚。
- Mould Manufacturing for Inlet Manifold Based on Rapid Prototyping 基于快速原型技术的进气歧管模具制造
- MPC Manifold Pressure controlled Fuel Injection 歧管压力控制燃料喷射
- Cause Analysis of Primary Reformer Inlet Manifold Damage 一段炉下集气管损坏原因分析
- The uses of this machine are manifold. 这台机器有多种用途。
- Inlet Manifold for Ford Car in Permanent Mold Casting 福特电喷进气歧管金属型重力铸造工艺
- Aluminum Alloy Inlet Manifold of Micro-car in Metal Mold Casting 铝合金进气歧管铸件的金属型铸造
- MPC Manifold Pressure Controlled Fuel Injection System 进气歧管压力控制燃油喷射系统
- The tide flushed through this narrow inlet. 潮水涌过了狭窄的小湾。
- Effects of inlet manifold dimensions on volumetric efficiency of engines 进气管结构参数对柴油机充气效率的影响
- Types of K050, K070, K095 have a good reasonable port and manifolds design.The percents (port and manifolds pressure drop / total pressure drop) is low, and flow maldistribution is not obvious. K050、K070和K095由于入出口设计合理，除入出口压降对总压降比例低外，分布不均的情形也不严重。
- There's only one inlet to the parking lot. 这个停车场只有一个入口。
