您要查找的是不是:
- injection pressure drop 喷注压降
- injection pressure drop method 注入压降法
- Watch pressure drop on pressure gauge. 手表压力在压力标准度量上降低。
- Valve exhibits high pressure drop. 阀门出现高压降。
- Injection pressure and holding pressure i. 注射压力和保压压力。
- DID THE PRESSURE DROP TO 0 PSI AND A "NO DRIVE" CONDITION OCCUR? 压力是否降至0PSI而且条件"NO DRIVE"出现?
- However, the pressure drop occurs almost completely in the plug. 然而,压力降几乎完全发生在多孔塞中。
- Drier operates in either flow direction with low pressure drop. 在任何一方向都可操作应用。
- The result indicated that GAE could reduced the pressure drop and moved the local exit stress concentration to the point of gas injection. 研究表明:气辅挤出可以降低压力降,将应力集中的位置由口模出口处转移到气体的注入点;
- Presents the theoretical model of pressure drop for flexible duct. 摘要介绍了柔性风管压力损失的理论模型。
- They are commonly used where a minimum pressure drop is important. 通常用在要求压降最小的应用场合。
- Injection pressure was 20 pis, 5 sec and power supply was 15kV constant. 自动气压进样;20pis;5sec.
- Read the pressure drop across the valve with a Watts Series PG meter. 利用美国瓦茨系列PG仪器读出通过阀门的压降。
- For compressible fluids, where pressure drop exceeds half the inlet pressure. 对于可压缩性流体,如果压降超过进口压力的一半。
- For non-compressible fluids, where pressure drop causes cavitation or flashing. 对于不可压缩性流体,如果压降产生空穴或闪蒸。
- Injection pressure of J-ELIII series is different from that of JSW's hydraulic machines. 注塑压力与油压系列不同。
- Maximum injection pressure and maximum holding pressure may be restricted due to molding condition. 有的情形下,最大注塑压力,最大保压压力会因成成形条件不同而受到限制。
- Colon hydrotherapy equipment can sustain a regulated and safe injection pressure to permit cleaning water to reach th extremities of the colon. 大肠水疗法设备能够维持一个规范和安全注射压力,让水清洗,以达到末端结肠。
- Increased needle injection pressure was obsered as the olume of PMMA increases and as the distribution of PMMA is in close proximity to the cortical walls. 同时,使用的聚甲基丙烯酸甲酯黏合剂的体积的增加还可以增大融合椎体的强度。
- Adjust balancing valve until pressure differential gauge reads pressure drop required for desired flow rate gpm. 调整平衡阀直到压差表读出压降符合所要求的流量(加仑/分钟)为止。