您要查找的是不是：
- Simulation of Step Response of Resistance Voltage Divider for Impulse Voltage 电阻型冲击电压分压器阶跃波响应的仿真
- impulse voltage divider 冲击分压器
- Each team builds a voltage divider with nom. 3.3 V output, and measure Vout. 每一组建立一个输出为3.;3伏特的分压器，测量输出电压。
- DC voltage divider can be used to design lower voltage direct current power. 直流分压器集开关电源和电能变换于一身，可以被用来设计降压型直流电源。
- The purpose: impulse capacitor is for impulse voltage and impulse current generator and resonance circuit. DC capacitor is for high voltage DC unit. 脉冲电容器用于冲击电压和冲击电流发生器及振荡回路中。直流电容器用于高压直流装置中。
- In the parafeed circuit, the power supply ripple forms a voltage divider across the choke, and is not coupled to the output. 在旁馈耦合中，电源涟波被扼流圈分压，而不再耦合进输出。
- The maximum impulse voltage that can appear at a point within a substation is usually the protective level that is held by the arrester. 变电站内某点所出现的最大冲击电压一般就是避雷器所具有的保护水平
- It gives the principle and method of design that coaxial capacitive voltage divider by the invar alloy. 给出了以因瓦合金为材料的同轴电容分压器的原理和设计方法。
- Finally, the paper presents a new type of user-defined, open structure with software defined system function impulse voltage analyzing system. 最后介绍了一种用户定义、硬件结构开放和系统功能软件化的新型冲击电压测量分析系统。
- The four resistors are connected in series, making a chain known as a potential divider, or voltage divider. 四个电阻串联接在一起，形成一个链形的分压电路。
- The principle, structure and output signal of an electronic voltage transformer based on a resistive voltage divider are different with that of a traditional voltage transformer. 基于电阻分压器的电子式电压互感器的原理、结构和输出信号等与传统的电压互感器有很大不同,其性能主要受电阻特性和杂散电容的影响。
- The result reveals that the stress control tube comprising a composite structure of the nonlinear resistive and capacitive material shows the best performance in uniforming the electric field distributions in cable terminations under impulse voltage. 分析结果表明，在冲击电压下电缆终端采用由电容性和非线性电阻性材料复合绝缘结构的应力控制管时，电场分布最为均匀。
- Ohm's law tells us electric current is equal to voltage divided by resistance. 欧姆定律告诉我们：电流等于电压除以电阻。
- According to the arrangement of thyristors in HVDC converter valve,the configuration of a high voltage resistive probe used for impulse voltage measurement has been designed especially. 根据高压换流阀中晶闸管的布置情况,设计了冲击电压测量用电阻型传感器探头的外形结构。
- To analyze the formation of surface discharge on a dielectric plate under positive nanosecond impulse voltage in air,a wire to plane electrode system with a barrier of negative film was used. 采用感光胶片作为阻挡介质的针-板放电系统,解析空气中固体电介质上纳秒正脉冲表面放电的形成过程。
- Test and improvement of voltage divider system of PMT for large area scintillating fiber array detector at RIBLL terminal[J].Nuclear Electronics & Detection Technology（in press, in Chinese）. RIBLL终端大面积闪烁阵列探测器光电倍增管分压系统的测试与改进[J].;核电子学与探测技术（待发表）
- The technical index and calibration level of the DC resistance voltage divider are analyzed,the uniform calibration method is proposed,the uncertainty is analyzed and the checking method is given. 分析了直流电阻分压箱的技术指标和校准水平，提出了等分测量的校准方法，进行了不确定度分析，给出了验证方法。
- Through the analyses of high voltage potential transformer,a mathematic model based on high voltage insulation theory of capacitor voltage divider varied with temperature are built. 通过对高压电压互感器分析,建立了基于高压绝缘理论的电容分压器随温度变化的数学模型;
- Efficiency of impulse voltage generator 冲击电压发生器效率
- The easiest way to accomplish this is to apply a potential across the entire tube and tap the dynode voltages off a voltage divider, as shown in Figure 4-13. 做到这一点最容易的方法是给整个光电倍增管的两端加上一个电压，然后从一个分压器的各个抽头取得供给各个倍增管电极的电压，如图4-13所示。
