您要查找的是不是:
- hour counter driving pinion 时计数器传动齿轴
- hour counter driving wheel 时计数器传动轮
- Refer to Drive Pinion Bearing Pre-Load Adjustment. 参阅驱动小齿轮轴承预荷调整。
- Worn teeth on ring gear or drive pinion gear. 环形齿轮或驱动小齿轮上齿磨损。
- End play in drive pinion bearings. 驱动小齿轮轴承的端隙。
- "A minute counter" also uses 60 to enter the system counter, every time accumulates 60 minutes, sends out "the hour pulse" the signal, this signal is delivered "the hour counter". “分计数器”也采用60进制计数器,每累计60分钟,发出一个“时脉冲”信号,该信号将被送到“时计数器”。
- The drive pinion is beveled at 45 degrees and engages the ring gear, which is also beveled at 45 degrees, causing the ring gear to revolve at 90 degrees to the drive shaft. 该驱动器齿轮是斜45度和参与的齿圈,这也是斜角在45摄氏度,造成齿圈旋转90度的传动轴。
- The driving power enters the differential through the drive pinion on the end of the propeller shaft. The drive pinion is meshed with a large ring gear so that the ring gear revolves with the pinion. 也就是说,驱动力是从传动轴末端的传动齿轮输送到差速器的。传动齿轮与一个很大的冠状齿轮啮合,传动齿轮驱动冠状齿轮。
- The ring gear is attached to the differential case so that the ease rotates with the ring gear when the latter is driven by the drive pinion. 冠状齿轮与差速器壳相连,这样当冠状齿轮由传动齿轮驱动转动时,差速器壳也转动。
- hour counter additional intermediate wheel 时计数附加中间轮
- An over-running clutch on the drive pinion prevents the starter from being driven by the engine once it starts. 在驱动小齿轮上的一个超转离合器可避免启动马达被引擎带动,一旦引擎启动了。
- hour counter operating lever hook 时计数器活动杆构压片
- hour counter operating lever spring 时计数器活动杆簧
- minute counter driving wheel friction spring 分计数器传动轮摩擦簧
- hour counter column wheel jumper 时计数柱轮跳杆
- minute counter driving wheel stud 分计数器传动轮桩
- On Problems about Starter Driving Pinion 也议起动机驱动齿轮工作问题
- The church bell tolled the hour. 教堂的鸣钟报时。
- The machine must break down at this busy hour. 正忙的时候,机器偏偏又坏了。
- He emphasized the importance of careful driving. 他强调小心驾驶的重要性。