您要查找的是不是：
- Developed excogitates of two decumbence and one hovizoutal molding die, realized increasing height of branch pipe of heat pressure tee and reducing radius of synodical arc of tee. 研制出两套立式模具和一套卧式模具,实现了用工艺方法增加热挤压三通支管高度,缩小三通相贯区内拐角处圆弧半径的目的。
- The ways to stop bleeding include direct pressure method and indirect pressure method. 止血方法可分为直接压法及间接压法。
- Thermal pressure method is part of resin inlaying, for which thermosetting resin is widely used. 热压镶嵌法属于树脂镶嵌法，其中，采用热固性树脂又是非常普遍的。
- Based on the analysis of molding principle about heat pressure tee of diameter equalize, suggested molding technics about diameter equalize. 在分析直径补偿热挤压三通成型机理的基础上,提出了直径补偿的成型工艺。
- Tension method also can distinguish permeability of different concrete, but it has discreteness compared with water pressure method. 通过研究张力法下水在混凝土中的渗透发现:水在张力法下更容易渗透,张力法下的渗透系数比水压法下大一个数量级。
- The result shows that heat pressure has weakly affected on flow because small difference in temperature and power of flow is caursed by induced draft fans. 分析表明由于温差很小,热压对流动的影响力较小,烟气流动的动力主要来自于排烟机本身。
- Thus, this experiment studies the seedling growth stage of different kinds of eggplants under the heat pressure and also researches relevant appraisal indices. 因此，本实验对热胁迫下不同品种茄子苗期的生长发育及相关鉴定指标进行研究。
- Breakthrough pressure method was presented in order to accurately determine the plugging position of water shutoff agent in oil reservoir. 为了能更准确地预测堵剂在油藏中的封堵位置,提出了堵剂突破压力法。
- The dynamic surface tension of aqueous solution of alkyl glucoside(APG) C_(8/10)G_(1.31) and C_(12/14)G_(1.43) was studied by using maximum bubble pressure method. 采用最大泡压法研究了表面活性剂烷基聚葡糖苷(APG或CiGj)C8/10G1.;31和C12/14G1
- Abstract: By comparison with new and old regulations of pile foundation, the paper points out faults of old regulations and advantages of new regulations when static pressure method is used to determine load-bearing capacity of single pile. 文摘:通过桩基础新、旧规范对比的论述，指出了在以静压法确定单桩承载力时，旧规范存在着的不足及新规范具有的优点。
- The static differential pressure method is used to study the cryogenic adsorption of hydrogen isotopes on the carbonaceous adsorbents, including activated carbon(AC), carbon molecular sieve(601) and carbon nano?fibers(CNF). 采用静态压差法研究了液氮温度下碳基吸附剂活性炭(AC)、碳分子筛(601)和碳纳米纤维(CNF)对氢同位素的吸附行为。
- In this thesis, the present studying status of the pressure method, the displacement method and the finite element method in the design and computing of anti-slide pile is introduced systemically. 本文详细介绍了抗滑桩设计计算压力法、位移法和有限元法的研究现状，分析了三种方法在应用中存在的问题，对有限元法进行了改进。
- Methods:The homemade-improve method and high hydraulic pressure method for syphilis of lacrimal passages of babies and infants were analyzed. 方法:自创改良型婴幼儿泪道冲洗法,高液压婴幼儿泪道冲洗法。
- Diameter Equalize Molding of Heat Pressure Tee 直径补偿热挤压三通的成型
- Based on static pressurizing method,the leakage and degassing rate of a dewar of 210 L was measured. 运用静态升压法对国内某厂家生产的210L杜瓦的漏放气速率进行测量;绘制了夹层压力随时间的变化曲线;测得总漏放气速率为2.;0×10-8Pa
- Presents the balance valve make-up water pressurization method used in substation reformation. 摘要介绍了在换热站改造中采用的平衡阀补水定压方式。
- Heat sometimes causes a prickly rash on the skin. 热有时使皮肤上生剌痛的疹子。
- Direct pressure and indirect pressure methods are most commonly used in first aid. 直接压法及间接压法是急救最常用的。
- Two methods of measuring conductance are introduced under the condition of molecular flow,namely,with constant volume method and constant pressure method. 在分子流条件下,给出了定容法和恒压法测量流导的方法,分析了测量不确定度。
- The system works on the principle that heat rises. 该项装置是按照热力上升的原理运转的。
