您要查找的是不是：
- The geographical distribution of heat flow data is very uneven. 热流量资料的地理分布很不平衡。
- Steady-state heat flow is comparable to the flow of an incompressible fluid. 稳态热流和不可压缩流体的流动可相比拟。
- The DSC method was adopted to analyze the heat flow of resin. Then, the activation energy was figured out respectively by Kissinger method and Flory method: 65.4kJ/mol and 65.80kJ/mol. 采用DSC对树脂进行了差热分析;利用Kissinger法和Flory法分别计算出了树脂体系的活化能为:65.;4kJ/mol和65
- Our result shows the nonuniform distribution of mantle heat flow in China. 结果显示;中国大陆地幔热流的空间分布不均匀.
- Icterus interferes the urease coupling method on determination of BUN, and makes the result a little to the low side. 结论:黄疸干扰了酶偶联法对bun的测定,使结果偏低。
- To understand the influence of icterus on urease coupling method for determining the serum urea nitrogen(BUN) . 了解黄疸对尿素酶偶联法测定血清尿素氮(bun)的影响。
- This is probably the most common output coupling method, as it is relatively simple. 因为这种电路非常简单，所以它可能是应用最广的电路。
- Takintg L-Arginine,L-Glycine and L-Aspartate as a raw material,used DCC coupling method to synthesize Arg-Gly-Asp(RGD). 以L-精氨酸、L-甘氨酸、L-天门氨酸为原料,采用二环己基碳二亚胺(DCC)法合成了Arg-Gly-Asp(RGD)。
- Heat flow from a hotter to a cooler body is a process of energy transfer tending to equalize temperature. 热从高温物体流向低温物体是一个能量传递过程，它使温度趋于均匀。
- Directional coupling method with software aided is used to suppress pulse shaped interferences. 对于脉冲型干扰，作者采用了软件辅助的脉冲定向耦合法进行抑制。
- Practical applications for heat flow measurements in ocean floors are the location of hot brines. 洋底热流量测量的实际目的是圈定热卤水的位置。
- Abstract: The numerical model for 3D fluid flow coupled with heat transfer was established with FDM and the free surfaces were handled by an improved SOLA-VOF technique. 摘 要: 采用改进后的SOLA-VOF方法处理自由表面，有效地克服了传统的SOLA-VOF法中的“施体-受体”法在处理三维自由表面时精度差和时间步长小的缺点。
- In this paper, load identification is studied in the time domain by combining the coupling method and the precise time integration method. 该文通过耦合方法与精细时程积分法的结合，对载荷辨识问题进行时域分析和推导。
- The approximation of a linear dependency between heat flow and temperature difference leads to satisfactory results. 在热流量与温度差之间，近似地采用线性关系，也能得出令人满意的结果。
- Based on the characteristics of aerothermoelasticity,the loose coupling method is used to establish the aeroelastic model. 基于热气动弹性的特点,采用松耦合方法建立气动弹性仿真模型。
- In short, heat flows from the warmer to the cooler body. 总之,热总是从高温物体流向低温物体。
- The two-dimensional elasto-plastic contact problems using element-free Galerkin-fmite element (EFG-FE) coupling method are studied. 对二维弹塑性接触问题的无网格伽辽金-有限元耦合方法进行了研究。
- The rate of heat flow between any two points increases with difference of temperature. 任何两点间的热流动速率则随温差的加大而增加。
- The EFG-FE coupling method for rigid-plastic materials is established.EFG and FE regions are connected by interface elements. 摘要建立刚塑性耦合无网格-有限元法，通过过渡单元将无网格区域与有限元区域相耦合。
- In heterogeneous anisotropic materials the heat flow vector and conductivity are more complex. 在各向异性的非均质材料中，热流向量和热导率很复杂。
