您要查找的是不是：
- The heat treatment temperature of EMD in Li-MnO2 batteries has great effects on comprehensive electrical performance of batteries. Li-MnO2电池用电解二氧化锰(EMD)的热处理温度对电池的综合电气性能有较大的影响。
- The heat treatment technology of carbo - nitriding of steel has the characteristic of lower treatment temperature and direct quenching. 钢的碳氮共渗热处理工艺具有共渗温度低、可直接淬火等特点。
- Increasing the semisolid isothermal heat treatment temperature can promote solute diffusion and quicken grain spheroidization speed. 提高半固态等温处理温度能促进溶质的扩散，加快晶粒的球化速度。
- The effects of doping ratio and heat treatment temperature on the structure and the electrical conductivity of ATO powder were studied. 研究了掺杂比、热处理温度等工艺条件对ATO粉体结构和导电性能的影响。
- The results from TGA show that the reactivity of the chars from YXV and JJV decreases with the increase of heat treatment temperature. TGA结果表明，热处理温度增加，蔚县煤镜质组(YXV)与湔江煤镜质组(JJV)焦炭的反应性降低；
- With the growth of heat treatment temperature or time, the crystallinity increase and the spherulite size and its distribution has a little change. 热处理温度的提 高或时间的延长均使结晶度逐渐增大，但平均球晶尺寸和球晶分布宽度变化不 大。
- As heat treatment temperature and time increased,surface acidic groups of PSAC decreased,while the basic groups increased,which was responsible for th... 经热处理改性后,沥青基球状活性炭的浸润性能有所降低。
- The influence of melting ambience,illumination time and heat treatment temperature on photosensitive of photoactive glass ceramic were studied.The samples were analyzed by XRD and SEM. 研究了熔制气氛、光照时间及热处理温度对铜光敏微晶玻璃光敏性的影响,利用XRD和SEM对样品进行了分析。
- The orthogonal experiment indicated that the descending order of factors influencing the properties of the FAC is as follows: molding pressure > heat treatment temperature > heat treatment time > ratio of binder. 正交实验结果表明;影响甲烷体积吸附量的因素由大到小依次为:成型压力>热处理温度>热处理时间>粘结剂的添加比例;并且得出了这种成型活性炭的最佳成型工艺;即:成型压力62.;5MPa;热处理温度250℃;热处理时间90min;粘结剂质量添加比例20%25。
- Through the orthogonal experiment, the content of DCP/TAIC, Si69, HAF, the order adding compounding ingredient, the heat treatment temperature, the temperature roasting HAF and their relationship were studied. 采用正交试验DCP/TAIC的用量、Si69的用量、HAF的用量、加料顺序、热处理温度和HAF的水分处理温度及其相互作用等进行了研究。
- The influence of technological parameter such as preheat temperature, heat treatment temperature, weld heat input and welding consumable on the weld of T91/P91 steel was synthetically analysed by means of SMAW during the course of welding process. 综合分析了手工电弧焊焊接过程中的预热温度、热处理温度、焊接线能量等主要工艺因素以及焊接材料对T91/P91钢焊缝性能的影响。
- The influences pf coprecipitation temperature, doping Antimony content, the type of dispersant, terminal pH value and heat treatment temperature on the particle size and powder resistance were discussed. 系统研究了共沉淀温度、掺锑浓度、滴定终点pH值、分散剂种类以及煅烧温度等对粉体粒径及电学性能的影响规律，对实验结果进行了讨论，优化实验条件，并进行了综合实验研究。
- Moreover, PPS fibers had been experimented on heat treatment, and some relations between dry heat shrinkage, tenacity retention and heat treatment time and heat treatment temperature were studied. 此外，对PPS纤维进行了热处理研究，探讨了纤维干热收缩率、强度保持率与热处理温度和热处理时间的关系。
- The overburnt temperature of 2E12 Aluminum alloy ingot studied by means of microstructure analysis and DSC.The homogenization temperature and heat treatment temperature were obtained. 摘要采用扫描电子显微镜和DSC差示扫描量热分析法，对2E12铝合金铸锭的过烧温度进行了研究，确定了铸锭均匀化处理温度及该合金板材的固溶处理温度；
- The results showed that the degree of preferred orientation within PAN-based carbon fibers increased with the increasing heat treatment temperature (HTT) and the ratio of hot stretching respectively. 结果表明：碳纤维中石墨微晶的择优取向性随石墨化温度的提高和热牵伸的增大而增加。
- The results showed that with the increase of heat treatment temperature,both the carbon content and tensile modulus of carbon fibers were enhanced,however the linear density decreased. 试验结果表明,随着热处理温度的提高,炭纤维线密度下降,微晶层间距缩小,碳含量、微晶尺寸和拉伸模量得以提高。
- The characteristic of magnetoresistance of C/C composite prepared by preform with needle-punctured carbon felt at different heat treatment temperatures(HTT) was investigated. 研究了针刺毡预制炭/炭复合材料(C/C)经不同温度石墨化处理后的磁电阻特性。
- Two types of petroleum coke were heated with different maximum heat treatment temperature ( T H,max ),the structure,morphology and graphitization degree of these samples were analyzed by means of XRD,SEM and Raman spectrum. 对两种不同的石油焦进行了高温热处理 ,采用 X射线、扫描电镜和 Raman光谱研究了经不同高温热处理温度 (TH,max)处理过的试样的结构、形貌、织构与石墨化度。
- Experimental Research on the Heat Treatment Temperature of Jadeite 翡翠热处理温度试验研究
- 今日热词
-
- 深远海浮式风电平台 - deep-sea floating wind power platform
-
- 京雄高速公路 - Beijing-Xiongan expressway
-
- 农业及相关产业增加值 - the added value of agriculture and related industries
