您要查找的是不是:
- graphitizing inoculant [机] 石墨化接种剂
- The influence of SG inoculant on graphitizing annealing of malleable cast iron was investigated. 研究了SG变质剂对可锻铸铁石墨化退火的影响。
- Inoculant is a very inexpensive input. 接种剂是一种非常便宜的投入。
- At same time, the ability of graphitizing and sectional hardness distribution of the gray iron inoculated by DWF inoculant had been given. 同时给出了其墨化能力、断面硬度及硬度差结果。
- Seed pelleting and inoculant manufacturiny technology have been studied. 对菌种特性及草场接种效果进行了鉴定。
- The components,modification and graphitizing annealing technology of ductile cast iron as-cast was researched. 对铸态可锻铸铁的材质、孕育处理及石墨化退火工艺进行了研究。
- High temperature graphitizing annealing kinetics for high manganese malleable cast iron has been investigated. 对高锰可锻铸铁的高温石墨化退火动力学进行了研究。
- The influence of inoculant addition amount on the structure and properties of camshaft was investigated. 试验了孕育剂量对凸轮轴组织和性能的影响。
- With the increase of the content of silicon, the high temperature graphitizing annealing time decreases. 随着硅含量的提高,完成高温石墨化退火的时间逐渐缩短。
- Medium M2 was suitable for the differentiation and grovwth of budlets,which appeared to be the best inoculant material. M2培养基适于皮上芽苞组织分化生长;且皮上芽苞组织为最好的接种材料。
- Its original heat treament processes were graphitizing annealing,quenching and tempering,then high-frequency hardening. 同时因齿条形状特殊,高频淬火时易将齿部完全淬透,不能满足用户要求。
- By microalloyed inoculant treatment,the austenitic grain size and microstructure can be remarkably fined. 经多元微合金变质处理,组织更为细小均匀,变为超细组织。
- The results show that high temperature graphitizing annealing can be carried out through altering the silicon content of the cast iron. 研究结果表明:适当调整可锻铸铁中的硅含量可以实现高锰可锻铸铁的高温石墨化退火过程;
- The inoculant TG-1 can replace ESCALOY as a patent inoculant to make Meehanite cast iron. The effect of them is contrasted by mathematics-statistics. 用TG-1代替ESCALOY作为生产密烘铸铁的专用孕育剂,并用数理统计对其作用进行了比较。
- All the bolts and screw holes of flanges must be supplied with graphit and moly bdenum disulphide to prevent. 由于吹灰器所处环境恶劣,所有法兰的螺栓、螺母的螺纹表面应涂抹石墨油脂或二硫化钼油脂加以保护。
- The inoculant block hasbeen used in foundry NO. 2 of DFL,and castings of QT450-10 are gained as-cast, theeconomic profit was obvious. 新型型内孕育块已在东风汽车公司有限公司铸造二厂完成生产性验证,在QT450-10材质的铸件上实现了铸态稳定生产,并获得了显著的经济效益。
- Based on these, making use of graphitizing expansion property to eliminate surface blowhole has been proposed and verified with tests. 基于此,提出了利用石墨化膨胀将已经产生的气体排挤出铁液来消除皮下气孔,并用实验进行了验证。
- Some techniques to improve the mechanical properties of V process castings, such as surface alloying, inoculant addition to the coating are presented. 也介绍了改善V法铸件机械性能的方法,如表面合金化,涂料中加入孕育剂等。
- It can be used to poiduce filling ring, graphit, strips, sealing mat, complex board, cylinder mats, etc. 可制做各种石墨填料环、带材、密封垫片、复合板、汽缸垫等。
- Application of Nodularizing Treatment of Graphite Inoculation by Wire Feeding Process in Foundry Production 喂丝法球化处理工艺在铸造生产中的应用