您要查找的是不是:
- general circuit parameter 一般电路参数
- Figure 4-7 depicts a general circuit for testing capacitor leakage. 图4-7是测试电容器漏电的一般电路。
- In the same time, making the design and simulation about the main electro circuit parameter and control circuit of the APF. 同时,对有源电力滤波器的主电路参数和控制电路进行了设计和仿真。
- The results show that the quantum noise in the dissipation microcircuit is determined by initial state of the circuit and the circuit parameter. 结果表明,微型电路中的量子噪声决定于电路初始状态和电路的参数。
- By using a small computer, the circuit designer can make more calculations covering many times of circuit parameter variations. 若利用小型计算机,电路设计人员就能进行较多计算,一次又一次地修改电路参数。
- Then the flow chart was found up on system function, integrating general circuit simulation software into database by designing the interface and the circuit level of mine fuze simulation realized. 在系统功能实现流程图的基础上,通过中间接口软件设计实现了数据库与通用电路仿真软件的集成,从而实现电引信的电路级仿真。
- The writer summarizes the cause of vacuum switching cutoff,and analyses the influence of circuit parameter on it ,such as the overvoltage,when the vacuum switch cuts off the induced charging circuit. 通过对真空开关截流成因的阐述,分析用真空开关切断感性负载电路时,电路参数对真空开关截流的影响,及由此产生的过电压危害.
- BUCK converter is a kind of typical piecewise-smooth dynamical system.Changing the circuit parameter, much dynamical behavior can appear.The dynamical model of the circuit was constituted. 摘要BUCK开关转换器是一种典型的分段光滑动力学系统,改变转换器的电路参数条件会产生许多动力学行为。
- A design method of low-power CMOS two stages amplifier working in the condition of subthreshold value voltage is introdluced,and an in-depth analysis of circuit parameter and performance is made. 因此提出一种工作在亚阈值电压范围内的低功耗CMOS两级运放的设计方法,并对电路的参数和性能做深入分析是很必要的。
- This paper simply analyzes pulse generating circuit,pre amplifier,power amplifier through examples. 通过实例对脉冲发生、预放(驱动)、功放电路进行了简要分析。
- Specified range in general circuit 一般电路的规定范围
- Boost converter and UC3854 are used in designing a 500W APFC circuit. The circuit parameters are calculated. 通过比较,选择Boost变换器为主电路拓扑,采用UC3854控制器,设计一容量为500W的单相有源功率因数校正电路,给出了具体电路参数的计算。
- Through keyboard and code generation circuit, coding and pulse modulation vibration with infrared project to form infrared project circuit. 通过键盘及代码生成电路、编码、脉冲调制振荡和红外发射构成红外发射电路。
- The dynamic of spacers in a short circuit is calculated by using simulative circuit parameters. 用模拟线路段参数计算了线路系统发生两相接地短路故障时,间隔棒承受的动力。
- The question for large generator circuit breaker (GCB) in power plant project design is the problem with different opinion in recent 10 years. 大容量火电机组发电机是否需要装设出口断路嚣(GCB),是近十几年来大型发电厂电气工程设计中争论较多,意见不一的问题。 主要原因是其目前主要依靠进口。
- Dai Hongyu, Zhou Runde. A sinusoidal power clock generation circuit for energy recovery logic. Microe-lectronics, 34(2004)1, 71 8722;76, (in Chinese). 戴宏宇;周润德.;用于能量回收逻辑的正弦功率时钟电路
- Gunner Jones was praised by the general. 炮手琼斯受到了将军的表扬。
- Revisable high voltage driving waveform generation circuit is designed, 2.Data storage and control circuit is designed. 3. 2、设计制作了可编辑的高压驱动波形产生电路,产生波形、时间参数、能量恢复时间参数等实时调节的高压驱动波形。
- Circuit parameters show a: 81db open loop gain, 82 degree phase margin, 123db CMRR, and power consumption around 6.2mW from 1.5V supply voltage. 电路参数为:81db的开环增益、87度的相位裕度、123db共模抑制比;以及在1.;5V电源电压下产生了约6
- Please give me a general idea of the work. 请告诉我这项工作的梗概。