您要查找的是不是:
- The ship grounded several times during berthed alongside wharf in Ulsan, Korea and Keelong, Taiwan in full load condition owing to not enough draft when low tide. 该轮满载靠泊在朝鲜和台湾期间因低潮时吃水不够造成多次搁浅。
- The camera has a full load of film. 这架照相机装有一整卷胶卷
- The plane took off with a full load. 飞机满载起飞。
- Test for taking on a full load suddenly. 突加负荷试验。
- The trucks has a full load capacity of six tons. 这辆卡车的车容是六吨。
- What kind of load conditions will the server be under? 服务器将处于哪种负载条件下呢?
- Typical droop is two cycles in frequency from no load to full load. 从空载到满载转速降一般为两赫兹。
- The nominal full load voltage and maximum voltage have been computed. 这样就可以计算出满负电压值和最大电压值。
- full load condition 满载状态
- The measured efficiency for AHB prototype circuit reaches 92.6% under low-line input and light load conditions. 非对称半桥雏型电路在低输入电压和轻载条件下,效率可达到92.;6%25。
- Finally, buffeting responses of the suspension bridge under forty-two kinds of load conditions are calculated. 最后计算了某悬索桥在42种荷载工况下的抖振响应。
- Asking John to run the department and teach a full load of courses is piling Pelion upon Ossa. 要约翰管理这个系,又要他上满工作量的课程,这是强人所难。
- The oil film of sliding bearing was squeezed and sheared in the dynamic load conditions. 滑动轴承在动载工作条件下运行时,承载油膜受到轴承挤压和旋转剪切两种运动作用。
- The parameters used in the analyses include rise to span ratio, slenderness ratio, steel ratio and load conditions. 分析的参数有矢跨比、长细比、含钢率以及加载方式。
- When ordering overload relays, specify horsepower, voltage and full load current per motor nameplate. 订购过载继电器时,请注明每台电机的功率马力、电压和满载电流。
- The happening of brittleness is related to the load condition. 脆性的发生和电力线路的负载状况有关;
- A constant 1.2 MHz switching frequency, with current-mode control scheme, provides stable low-noise operation at high load conditions. 恒定的1.;2 MHz开关频率及电流模式控制配置可确保高载荷条件下稳定的低噪音操作。
- The ratio of output power to input power expressed as a percentage. This is generally measured under full load at nominal line voltage. 输出功率与输入功率之比的百分数。通常是在满负荷额定线电压下测定的。
- This results in easy mounting and dismounting, particularly where the load conditions are such that interference fits are required for both rings. 这使安装和拆卸容易,特别是在载荷条件要求两个轴承圈都带过盈配合的情况下。