您要查找的是不是：
- This paper is mainly introduced the flow ratio control system of powder of KCL which is proportional to sulfate and phosphorvlation. 分析了人工加氯系统的不足,通过估计流量实现了比值控制;介绍了串级控制结构,建立了过程模型。
- automatic flow ratio controller 自动流量比例控制器
- flow ratio controller 流量比率控制器
- flow ratio control system 流量比值控制
- The deficiency of manual chlorine dosing syste m was analyzed, and ratio control was achieved by estimating the flow rate. 分析了人工加氯系统的不足,通过估计流量实现了比值控制;介绍了串级控制结构,建立了过程模型。
- The greater the secondary cooling water flow ratio, the easier the spindly primary dendrites and narrow PDAS formed. 二次冷却水流量比增加，易形成细长的一次枝晶，一次枝晶臂间距降低。
- The weaving flow ratio has no influence on the weaving length when the traffic reaches to possible traffic capacity. 当交通量较大时，交织流量比对交织长度与区间平均速度的关系影响较大；
- The results show that the fuzzy sliding mode control method in the slip ratio control of ABS is valid. 结果表明,模糊滑模控制方法在ABS的滑移率控制中是切实有效的。
- The engine and speed ratio control models are established, and the matching strategy of CVT vehicle is studied. 本文从金属带式无级变速传动的传动机理入手，通过建立发动机和无级变速器的速比变化率模型，研究了发动机与无级变速器的匹配控制策略。
- AIM: To observe the change of flow ratio of saliva, pH value and numdber of streptococcus mutans after wearing removable partial denture(RPD). 目的 :观察和探讨可摘局部义齿对口腔唾液流率、pH值及变链菌数的影响机制和特点。
- Motor Generator 1 is the engine starter, generator, and transmission ratio control. 电动发电机1发动机起动机，发电机，和传动比控制。
- A gas-liquid two-phase flow ratio equation through Venturi tube is deduced based on the separated-phase model from the Bernoulli equation. 摘要从伯努利方程出发，基于分相流模型，推导出气液两相流流过文丘里管的流量公式。
- Then, using support vector machine classifier to conduct quality classification on speed ratio control valve. 然后，使用支持向量机分类器对速比控制阀进行质量分类。
- You have to put the burnt-out ratio control in flammable materials flammability range. 必须要把燃空比控制在易燃材料可燃极限的范围内。
- In deferent inking system,the ink thickness distribution and the ink flow ratio is different for the deference of the number of roller and the arrangement of the roller. 同时,墨辊上墨层厚度及着墨率的变化与输墨系统的墨辊数量及排列方式均存在一定关系。
- The effects of different parameters which include the flow ratio of SiH4, the flow ratio of H2 and substrate temperature were investigated by means of RHEED, TEM and AFM. 利用反射高能电子衍射(RHEED)、透射电子显徽镜(TEM)和原子力显微镜(AFM)研究了 SiH4流量、H2流量和衬底温度等工艺参数的改变对薄膜晶化的影响。
- By comparing traditional DTC approach with FNN duty ratio control scheme,the effectiveness of FNN duty ratio control scheme was verified. 将传统的直接转矩控制方案和模糊神经网络占空比控制方案进行了比较研究;仿真结果校验了模糊神经网络占空比控制方案的有效性.
- In the dynamic adsorption experiment, at 26 C, on the condition of flow ratio 2. 12 10-4m3/m2s, bed height 25cm, saturation adsorption quantity is 0.07536mg/g. 在动态吸附实验中，在26℃、进料流率为2.;12×10~(-4)m~3/m~2s、床层高度为25cm时，饱和吸附量为0
- BRR - Balanced Ratio Regulators are designed to provide accurate air/fuel ratio control of cross-connected combustion systems. BRR比例阀是专为提供精确的空气燃气比例而设计的。
- First , the deposited films were characterized as a function of argon-oxygen gas flow ratio, deposited time, substrate temperature, and annealing temperature. 我们首先设计不同的制程参数：控制氩气与氧气的比例、溅镀时间、改变基板温度及退火处理温度；
