您要查找的是不是:
- feed water flux 给水流量
- Automatically feed water for boiler. 锅炉自动给水。
- Design flux varies depending on feed water quality or system design basis. Customers are requested to consult with Asahi Kasei Chemicals Corporation. 设计透水量随进水水质和设计条件不同而改变,有关详情请向本公司咨询联系。
- Raw water Flux: Check whether system has sufficient raw water. 原水流量:检查系统是否具备充足的原水。
- Cooling water flux should be accord with the design requirement. 冷却水流的流量应根据冷却器的设计要求。
- As the products of combustion circulate,they heat and feed water. 燃烧产物循环时便加热供水。
- As the products of combustion circulate, they heat and feed water. 燃烧产物循环时便加热供水。
- Disassemble,clean and check the automatic feed water regulator. 将自动给水调节器拆开、清洁并检查。
- The properties were measured by the pure water flux and rejection of egg albumin. 结果发现:二氧化硅的含量,不仅显著影响膜结构和性能;
- The technology of hot dip aluminized coatings on ferrous products by water flux methods in studied. 研究了水溶剂法钢铁表面热浸镀铝工艺;
- Cleaning can eliminate surface contamination of membrane and recover the water flux. 膜清洗可将膜表面的污染物去除,达到恢复透水量的目的。
- The change laws of pore size, water flux and retentivity of the membrane with pres-sure are investigated. 论述了不同配方铸膜液制成的膜,其孔径、水通量和截留率随操作压力的变化规律。
- As a result,ground water flux into excavations may be indirectly used as an index to evaluate elastic modulus Em. 借助等效水力模型,用涌水量大小来描述岩体的弹性模量。
- The Watts Feed Water Pressure Regulator must be installed on the cold water supply line to the boiler. 美国瓦茨进水压力调节阀必须安装在通往锅炉的冷水供应管道上。
- The valve shall contain a Watts Regulator Model 9D backflow preventer and Model 1156 feed water pressure regulator. 这种阀门包含美国瓦茨调节阀型号9D防倒流阀和型号1156进水压力调节阀。
- It is found that the entraining water flux decreases at first, reaches a minimum, and then increases with the increase of the liquid film velocity. 在两管间隙和气流速度一定的条件下,液膜流速对气流的带液量也存在影响,随着液膜流速的增大带液量先减少后增加。
- Filtration method is subject to feed water quality. Consult Asahi Kasei Chemicals Corporation for further information. 根据进水水质不同,可以选择不同过滤方式,有关详情请向本公司咨询联系。
- The coupling point was a water flux term at the phreatic surface through which the unsaturated zone linked with the saturated one. 一维非饱和模型与二维饱和模型的耦合点为非饱和带计算所得的通过潜水面的流量项.
- Feed Water Piping, Main Steam Piping, Reheating Steam Piping (Hot), Reheating Steam Piping (Cold). 如果指锅炉部分的给水,主蒸汽、再热(热)和再热(冷)的话,应该是: