您要查找的是不是：
- A joint J is typical of those at which there is no external load. 节点J是无外荷载作用的典型节点。
- Under the influence of the external loads, the body B moves and deforms. 在外加负荷的影响下，物体b将运动和变形。
- Under the influence of the external loads , the body B moves and deforms. 在外加负荷的影响下，物体B将运动和变形。
- Each such beam is subjected to the external loads that normally act upon it, together with the two redundant moments at its ends. 每一根这样的梁承受垂直作用于其上的外荷，以及两端的两赘余弯矩。
- The structure may sustain more than one load, but it must be assumed that all external loads are proportional. 结构可以承受一个以上的荷载，但必须假设所有的外荷载是成比例的。
- "Direction of load indeterminate" represents variable external loads, shock loads, vibrations and unbalance loads in high-speed machines. “不定向负荷”表示高速机器中变动的外在负荷、冲击负荷、振动及不平衡负荷。
- The method can be applied to slopes with any configuration, different layering and external load distribution. 该方法适用于任意几何形状、不同岩土材料分层以及多种荷载作用的复杂边坡。
- The mudstone can slake severely under the conditions of unloading,weathering,water and external load effect. 通过扫描电镜和X射线衍射,分析底板泥岩的矿物组成,并对其泥化机制进行研究。
- When actuation device stops at any position, a locking function is applied to avoid the displacement of actuation device due to external load. 其可使执行机构在任意位置停止后,加以可靠的锁定作用,从而避免执行机构在外界载荷作用下可能发生的位移。
- It is obvious that a concrete member cracks in tensional area as the external load comes to 14% of its ultimate load or so. 研究表明，当外荷载为极限荷载的14%25左右时，钢骨高强混凝土构件受拉区混凝土开裂；
- The liquid's motion induces a streaming current that is fed through an external load resistor to harvest electrical energy from the fluidic system. 液体运动产生的电流流经一个外加电阻，便可从流体系统中收取电能。
- And the displacement of MFPs is very small under the random external loadings. 同时，在同样的随机载荷作用下，巨型框架抗振平台具有比较小的振动位移。
- A family of straight lines (passing through origin) of the indenter's curvature versus the external load under different contact zone is obtained. 由此可以得到以接触区尺寸为参数的接触 压力与压头曲率的关系直线族。
- But this method is not suitable for the case where the external load is transmitted via a chain of parts with clearances existing at their joints. 但当外加载荷是通过几个联接处有较大间隙的零件传递至螺栓时，这种分析方法就不再适用。
- Involving interaction of gasket, bolts and flange rings, the load-deformation and the structural fuzzy reliability of each component are analyzed in the case of ideality, external loads and creep-relaxation respectively. 本文将垫片、螺栓和法兰作为一个相互作用的整体，比较深入地分析了理想情况下、有外载作用及蠕变-松弛影响下，平垫片和0形圈这两种典型的火箭发动机法兰连接系统各元件的载荷与变形、元件的结构可靠度和火箭发动机法兰系统的密封可靠度。
- External load has great effect on output rotational speed.Adjusting applied field and using different ERF are effective ways to keep output rotational speed constant. 外加负载对输出转速影响较大，为了保证恒定的输出转速，可通过调节外加场强和选择适当的ERF实现。
- The changes of the interfacial shear stress under the preload and the external load and the distribution of the effective tension stress in the CFRP sheers were calculated. 研究了界面间剪应力在预应力荷载和外荷载作用下的变化规律以及放张后碳纤维中的有效拉应力分布状况。
- A method was presented to identify and calculate inversely the casing external loads by the displacement data of the casing wall.The application of the proposed method was discussed. 基于套管内壁变形的实测资料，利用阻尼最小二乘法建立了套管外载反分析模型，提出了确定套管外载的反分析方法，讨论了反分析法的应用。
- By combining the interval mathematics and the finite element analysis, the mass matrix, damping matrix, stiffness matrix and the external loads are represented as interval matrices and vector. 通过结合区间数学和有限元分析，结构质量矩阵、阻尼矩阵、刚度矩阵和外载荷列向量采用区间矩阵和区间向量来描述。
- As increasing external loads, from part yield to plastic expanding, stress is dstributed again, at last two models are yielded axisymmetrically, there is no buckling characteristic. 随着静水外压的增加，模型结构从局部屈服到塑性区扩展，应力重新分布，直至发生轴对称屈服破坏，未见失稳特征。
