您要查找的是不是：
- A joint J is typical of those at which there is no external load. 节点J是无外荷载作用的典型节点。
- The liquid's motion induces a streaming current that is fed through an external load resistor to harvest electrical energy from the fluidic system. 液体运动产生的电流流经一个外加电阻，便可从流体系统中收取电能。
- Load current is set in 1.56% increments of the maximum value. 负载电流在最大值增量的1.;56%25中设置。
- Moisture proof and no contact output, Load current 1A max. 具防潮功能并且采用无接点方式，限时控制负载电流最大1A.
- The method can be applied to slopes with any configuration, different layering and external load distribution. 该方法适用于任意几何形状、不同岩土材料分层以及多种荷载作用的复杂边坡。
- The mudstone can slake severely under the conditions of unloading,weathering,water and external load effect. 通过扫描电镜和X射线衍射,分析底板泥岩的矿物组成,并对其泥化机制进行研究。
- When ordering overload relays, specify horsepower, voltage and full load current per motor nameplate. 订购过载继电器时，请注明每台电机的功率马力、电压和满载电流。
- The load current is handled directly by the controller through semiconductor switching devices. 负荷电流由调节器通过半导体开关元件直接控制。
- When actuation device stops at any position, a locking function is applied to avoid the displacement of actuation device due to external load. 其可使执行机构在任意位置停止后,加以可靠的锁定作用,从而避免执行机构在外界载荷作用下可能发生的位移。
- It is obvious that a concrete member cracks in tensional area as the external load comes to 14% of its ultimate load or so. 研究表明，当外荷载为极限荷载的14%25左右时，钢骨高强混凝土构件受拉区混凝土开裂；
- The peak load current limit is set by the user's selection of a reference voltage and current-sensing resistors. 用户可通过选择参考电压和电流感测电阻设置峰值载荷电流限制。
- A family of straight lines (passing through origin) of the indenter's curvature versus the external load under different contact zone is obtained. 由此可以得到以接触区尺寸为参数的接触 压力与压头曲率的关系直线族。
- But this method is not suitable for the case where the external load is transmitted via a chain of parts with clearances existing at their joints. 但当外加载荷是通过几个联接处有较大间隙的零件传递至螺栓时，这种分析方法就不再适用。
- An "Overcurrent Relay" is a type of protective relay which operates when the load current exceeds a preset value. 过电流继电器是继电保护装置的一种，当负载电流超过整定值时，继电器动作。
- Under the influence of the external loads, the body B moves and deforms. 在外加负荷的影响下，物体b将运动和变形。
- Choosing the load current phasor as the reference for the phasor diagram analysis is straightforward and effective. 以负载电流相量为参考的新的相量图分析方法是简洁有效的；
- And the displacement of MFPs is very small under the random external loadings. 同时，在同样的随机载荷作用下，巨型框架抗振平台具有比较小的振动位移。
- Under the influence of the external loads , the body B moves and deforms. 在外加负荷的影响下，物体B将运动和变形。
- The current distribution in fuses is discussed when high frequency components are present in the load current. 还讨论了在负载电流中引入高频分量时熔断器中的电流分布问题。
