您要查找的是不是：
- The exhaust valve on my car have burn out three times. 我车子上的排气阀已烧坏三次。
- The exhaust valve on my car has burnt out three times. 我车子上的排气阀已烧坏三次。
- exhaust valve spring 排气阀弹簧
- The exhaust valve seats skimmed up. 排气阀座整新。
- The exhaust valve on my car has burnt out. 我汽车上的排气阀烧掉了。
- Lock the exhaust valve in its open position. 把排气阀固定在它开启的位置。
- Remove valve spring and retainer. 拆卸阀弹簧和扣件。
- CAUTION: The check valve spring is in compression. 警告：止回阀弹簧处于压缩状态。
- So the exhaust valve opens before BDC and closes after TDC. 因此排气门在下止点之前打开，在上止点之后关闭。
- For removal of valve stem seal and lower valve spring guide. 可用于拆卸汽门油封或降低汽门弹簧。
- When the piston nears the top of this stroke, the inlet valve is opened and the exhaust valve closed. 随着曲轴转动，复又向上带动活塞，同时废气经由气缸头盖上的排气阀排出。
- Due to the release of pressure when removing the cover, the relief valve spring may eject quickly. 因为在拆卸阀盖时松开压力，安全阀弹簧可能会快速弹出来。
- Failure analysis on the exhaust valve skirt used in supercharge diesel engine was carried out through metallographic and SEM analysis. 利用金相及扫描电镜对增压柴油机排气门盘部断裂原因进行了分析。
- Multi - purposed optimal design of reliability for valve spring based on fuzzy method. 基于模糊学方法的气门弹簧可靠性多目标优化设计。
- The air helps to heat the exhaust gases and burn off toxic gases as they escape from the engine cylinder as the exhaust valve opens. 当排气阀打开，废气毒气从发动机气缸里逸出时，这种气体有助于加热废气，烧掉毒气。
- Remove the relief valve cover, stem/diaphragm assembly, and relief valve spring. 拆卸安全阀阀盖，阀杆/隔膜总成，和安全阀弹簧。
- When the gas cylinder when the exhaust pressure to achieve, when the exhaust valve 4 is opened, the gas was discharged to complete a working cycle. 当气缸内的气体达到排气压力时，此时排气阀4被打开，气体被排出，完成了一个工作循环。
- Install a dial indicator so plunger contacts valve spring retainer as nearly perpendicular as possiblZero the indicator. 安装一个表盘式指示器，使柱塞与气门弹簧护圈尽可能垂直。将指示器调零。
- The helium liguefier is a Claude system,with liguidnitrogen precooling,one expansion without the exhaust valve,and Joule-Thomson expansion,20 litre hour is produced. 它是带单阀膨胀机;有液氮预冷和J-T膨胀的克劳特循环系统;产量为20升/时.
- Check whether or not the fuel injection pump plunger and fuel outlet valve is worn or clogged, plunger spring and fuel outlet valve spring is broke. 喷油泵柱塞及出油阀是否磨损或卡死、柱塞弹簧及出油阀弹簧是否折断；
