您要查找的是不是:
- exhaust pipe flange gasket 排气管凸缘密封片
- The tail exhaust pipe of the motor vehicle emitted poisonous smoke. 机动车的尾部排气管排出有毒的浓烟。
- exhaust pipe flange seal 排气管凸缘气封
- Install exhaust pipe at soldering area. 安装排气管于焊接区。
- Each main exhaust pipe shall have one exhaust fan. 一个风机控制一个主要的排气管道。
- Combining with flange joints fact and the ASME B16.20 to spiral wound gasket request, such as PN 6.3 MPa pipe flange in HG standard, the seating stress of spiral wound gasket was analyzed. 结合法兰连接的实际;按照ASMEB16.;20对缠绕式垫片压缩的要求;以HG标准中PN6
- External air duct and exhaust pipe connector. 外置式出入油管连接座。
- Cars will discharge fumes from the exhaust pipe. 汽车会从排气管中排放废气。
- The slight decrease in the spools length is to accommodate the flange gasket, approximately 1/8". 稍微增加短管长度以适应法兰垫圈,大约1/8英寸。
- The urethane liner extends over the flange face to serve as the valve's flange gasket. 这种氨基甲酸乙酯延展覆盖到法兰表面,起到阀门法兰衬垫的作用。
- Note: The flange gasket bolts for the gate valves should be retightened during installation as the bolts may have loosened due to storage and shipping. 注意:闸阀的法兰垫圈螺栓在安装期间应该重新紧固,因为在库存和运输时这些螺栓可能会松懈。
- Install the exhaust pipe support and tighten the screw. 安装排气管支架并拧紧螺丝。
- The flange gasket bolts for the gate valves should be retightened during installation as the bolts may have loosened due to storage and shipping. 在安装期间,闸阀上的法兰垫圈螺栓应该重新紧固,因为在库存和运输时螺栓可能会松懈。
- Usually made of exsufflation knitware, and exhaust pipe. 凡是由排气马达及排气惯所构成。
- Seat Face: Negates need for flange gaskets. 阀座表面:不需要使用阀兰垫圈。
- Installation Note: The flange gasket bolts for the gate valves should be retightened during installation as the bolts may have loosened due to storage and shipping. 安装注意事项:在安装期间,闸阀上的法兰垫圈螺栓应该重新紧固,因为在库存和运输期间螺栓可能松动。
- Dimensions of gasket for pipe flange 钢管法兰用垫圈尺寸
- The exhaust pipe shot sparks. 排气管中射出了火星。
- INSTALLATION NOTE : The flange gasket bolts for the gate valves should be retightened during installation as the bolts may have loosened due to storage and shipping. 安装注意事项:在安装期间,闸阀上的法兰垫圈螺栓应该重新紧固,因为在库存和运输期间螺栓可能松动。