您要查找的是不是：
- encoder data block 编码器数据块
- The dialog box data block was missing or invalid. 对话框数据块不存在或无效。
- The WMI data item or data block is read only. WMI数据项目或数据块为只读。
- The block cipher mode encodes data one block at a time. 块密码模式一次一块对数据进行编码。
- Glue to 3D stack, data block, or data chunk to add a range label. 粘附到三维堆栈、数据块、数据区块，以添加范围标签。
- Row IDs determine sort sequence within a Data Block. 决定排序顺序。
- Including trailing bytes at the end of the previous data block. 所保留的任何状态信息,包括前一个数据块结尾的尾部字节。
- The WMI data block or event notification has already been enabled. WMI数据块或事件通知已启用。
- The WMI operation is not supported by the data block or method. 数据区块或方法不支持WMI操作。
- The WMI data block or event notification has already been disabled. WMI数据块或事件通知已禁用。
- Leaving out the expensive special decoding IC, this interface combines motor control with receiving encoder data on one DSP, which can simplify system design and reduce product cost. 接口省去了昂贵的专用解码芯片，仅依靠DSP实现电机驱动和编码器数据接收，大大简化了系统设计，降低产品成本。
- Place under 3D stack top, below or above a data block or data chunk. 放在三维堆栈顶部之下，数据块或数据区块之下或之上。
- Leaving out the expensive special decoding IC,this interface combines motor control with receiving encoder data on one DSP,which can simplify system design and reduce product cost. 接口省去了昂贵的专用解码芯片,仅依靠DSP实现电机驱动和编码器数据接收,大大简化了系统设计,降低产品成本。
- The stream cipher mode encodes data one bit at a time. 流密码模式一次一位对数据进行编码。
- By organizing data block partition, two layer nested bintree were built. 在数据分块组织的基础上构建了两层嵌套二叉树。
- Any method for encoding data to reduce the sto-rage it requires. 任何可以缩减其需占用存储空间的对数据进行编码的方法。
- IDEA works on 64 bit data blocks with a 128 bit key. IDEA用128位密钥处理64位数据块。
- Drag onto the page, then glue to 3D stack, data block, or data chunk to add a range label. 拖到绘图页上，然后粘附到三维堆栈、数据块、数据区块，可以添加范围标签。
- Drag onto the page, then place under 3D stack top, below or above a data block or data chunk. 拖到绘图页上，然后放在三维堆栈顶部之下，数据块或数据区块之下或之上。
- Trailing bytes at the end of the data block are stored in an internal buffer and used in the next decoding operation. 则位于数据块结尾的尾随字节将存储在内部缓冲区中,并在下一次解码操作中使用。
