您要查找的是不是:
- electric breakdown voltage 电击穿电压
- Based on the analytical model, the dependencies of the electric field distribution and breakdown voltage on the device parameters are investigated. 借助解析模型,研究了电场分布和器件击穿电压与结构参数的关系。
- Features: High breakdown voltage, low output capacitance, high fT. 特点:高击穿电压,低输出电容,特征频率高。
- Purpose: Color TV chroma output and high breakdown voltage driver. 用途:用于彩电行输出和高击穿电压驱动。
- Experiments snow that adding 10% air to SF6 gas can apparently increase the lightning impulse breakdown voltage of SF6 in a highly non-uniform electric field. 实验表明,在SF_6中加入10%25的空气可明显提高在极不均匀电场中的雷电冲击击穿电压。
- Features: High breakdown voltage, excellent current characteristics. 特点:击穿电压高,电流特性好。
- Lastly, by means of a mass of experiments on the vacuum interrupter arrangements with single break or triple breaks in series, the breakdown voltage improvement factor, breakdown statistical property and electric distribution in breaks are researched. 因此;应该通过设计最大限度地提高多断口真空开关各断口的电压分布均匀性;从而提高其击穿电压增益倍数;最大限度地发挥多断口真空开关的优势。 本研究还设计和制作了40.;5kV电压等级的光控模块式真空开关单元样机;进行了样机的动作精度实验。
- Investigation of high voltage electrical breakdown of pressurized glycol/water mixture with microsecond charging[J]. 引用该论文 张自成;张建德;杨建华;周相.
- Test results show that the corona's onset and breakdown voltage both rise with increasing OD of the nozzle. 结果表明:喷嘴外径增大,起晕电压和击穿电压升高。
- The clamping snubber circuit was set to the rated breakdown voltage of the MOSFET (600 V and 800 respectively). 钳位缓冲电路被设定在场效应晶体管的额定击穿电压上(分别为600伏特和800伏特)。
- Simulation result shows that nearly 100% breakdown voltage of the plane junction can be realized. 模拟结果显示,该结构可以使射频功率双极性晶体管的击穿电压几乎100%25达到平行平面结的理想值。
- If the critical reverse breakdown voltage is exceeded, a destructive breakdown occurs. 如果超过临界反向击穿电压,就会发生破坏性的击穿。
- This paper investigates the DC breakdown voltage in the two-phase mixture that is composed of air and mist. 研究了空气和雾组成的气液混合两相体在球-球电极中的直流击穿电压。
- Two important features of high-voltage (HV) devices are a low on-resistance (Ron) and a high breakdown voltage (VBV). 高压元件所追求的两个主要特性即:低的导通电阻及高的崩溃电压。
- Features: High breakdown voltage, low collector saturation voltage, high speed switching. 特点:击穿电压高,饱和压降低,开关速度快。
- The deposition rate,morphologies,breakdown voltage and refractive index were studied. 研究了制备工艺对薄膜沉积速率、表面形貌、折射率和电击穿场强的影响。
- The result showed that burying sintering process may make breakdown voltage smaller and apparen. 结果表明,采取粉料埋烧可以明显降低压敏电压、提高介电常数。
- This enhancement may act like a finger near a doorknob, briefly raising the electric field to the point where a conventional electrical breakdown can take place. 这种作用可能类似门把附近的手指头,使电场短暂增强到一般电崩溃的发生点。
- Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies (10. 固体电绝缘材料在工业电源频率下的介电击穿电压和介电强度的试验方法(10。
- The field limting ring (FLR) termination structure theory is analysed, the related factors that influence breakdown voltage are summarized. 分析了场限环结构原理;总结了影响击穿电压的相关因素.