您要查找的是不是:
- Base Station Destroy all enemies to advance! 消灭所有敌人过关。
- Enter the base station password if necessary. 如有必要,请输入基站密码。
- Too far away from the nearest base station. 因为距离最近的基站太远了。
- It utilises the LED flash unit of the regular base station. 照相机使用普通底座的LED闪光灯。
- Interpreted presentation of base station fault and alarm status. 翻译基站故障和告警状态的表示。
- Remove an RCS to take the RCS and attached base station out of service. 退出某个 RCS 以使该 RCS 及附加的基站退出服务。
- Plug the hard disk into the USB port on the back of the base station. 将硬盘插入到基站背面上的USB端口。
- Nearby base stations using adjacent channels. 使用相近频道的相邻基站。
- LEMP is a very important factor of EMI for the Base station of WLAN. 雷击电磁脉冲(LEMP)是远程无线局域网基站的重要电磁干扰(EMI)因素。
- NCO is an important part in software radio transceiver of CDMA base station. 数控振荡器 (NCO)在 CDMA基站的软件无线电收发机中 ,起着非常重要的作用。
- The sectored array antenna is applied to the base station of TD SCDMA. 该天线阵列用于TD SCDMA基站系统中。
- The microbrowser on the wireless device sends a request to the wireless network base station. 无线设备上的小型浏览器向无线网络基站发送一个请求。
- The user handofF algorithm can reduce the number of handoff and balance the load among mobile base stations in dynamic topology. 在网络动态变化时,用户切换管理算法可以减少用户的切换次数,使用户负载分布均匀。
- In short, ABR provides for transport of traffic at the bit rate available at the time, and on a dynamic basis. 简而言之,ABR在某一时刻,在比特率有效并且在动态的基础上提供传输业务。
- The request is sent from the base station over the wireless network using the Wireless Transport Protocol (WTP). 基站发出请求,使用无线传输协议(WTP) 在无线网络中传输。
- Powerful, flexible 5-stereo bus, 24-bit digital effects engine offering a wide range of time, frequency and dynamic based effects as well as effects chaining. 强大,灵活的5立体声总线,24位数字的影响引擎提供了广泛的时间,频率和动态的影响以及影响链接。
- The Remove button is used to disconnect all attached base station sites from the MSC. Remove 按钮用来从 MSC 断开所有附加的基站。
- If you try to remove a DS0 for which the end point connection_ base station or CDM_is in service,the remove fails. 如果试图要使某个端点连接--基站或 CDM--处于服务中的 DS0 退出服务,则退出服务失败。
- If you try to remove an AP DS0 for which the end point connection_ base station or CDM_is in service,the remove fails. 如果试图要使某个端点连接--基站或 CDM--处于服务中的 DS0 退出服务,则退出服务失败。
- During a switchover,the connections remain established between the AP and the base station signaling links. 在切换期间,仍会保持 AP 和基站信令链路间建立的连接。