您要查找的是不是：
- dynamic address bus 动态地址总线
- Can check ADDRESS BUS or DATA BUS circuit open short or not. 可知ADDRESS BUS或DATA BUS信号本身有无开短路情形。
- The microprocessor uses the address bus to locate data stored in memory. 微处理机使用地址总线设定在存贮器中存贮的数据的地址。
- A memory map is the addressing plan for the address bus bits. 存贮器布局就是地址总线各位的寻址平面图。
- So that the entire DMA transfer address becomes available on the address bus. 以使整个DMA传输地址有效。
- Address Bus:Locates data stores in the memory,input port, or output port. 地址总线：确定数据在存储器，输入口或输出口中的存储位置。
- The irredundant sorting bus encoding method reduces the power dissipation of highly capacitive memory address bus based on the dynamic reordering of the modified offset address bus lines. 提出了一种新的低功耗非冗余排序总线编码方法,通过对改进的偏移地址线的动态重排以降低具有高负载的地址总线的功耗。
- By default, dynamic address translations will time out from the NAT translation table after a period of non-use. 一般来说，动态地址的转换在一段时间没用之后，将会在NAT的转换表格当中失效。
- One problem with BOOTP, however, is that it was not designed to provide dynamic address assignment. 然而，BOOTP的一个问题是它不是设计来提供动态位址的指定。
- A memory address consists of binary data being output on an appropriate bus which we call the address bus. 一个存储器地址是由输出到适宜的总线上的二进制数据所组成。这个总线我们称为地址总线。
- The system bus is divided into three logical functions; the address bus, the data bus and the control bus. 系统总线的功能在逻辑上被划分为三部分：地址总线、数据总线和控制总线。
- The system bus is divided into three logical functions: the address bus,the data bus and the control bus. 系统总线的功能在逻辑上被划分为三部分：地址总线、数据总线和控制总线。
- Methods Dynamic address code design and automatic compositor algorithms were integrated into the software design, while the running out was eliminated by adopting watch dog chip. 方法：在软件中采用动态地址码设计与自动排序算法，在硬件上增加看门狗芯片，避免程序“跑飞”的情况。
- Methods Dynamic address code design and automatic compositor algorithms were integrated into the software design,while the running out was eliminated by adopting watch dog chip. 方法:在软件中采用动态地址码设计与自动排序算法,在硬件上增加看门狗芯片,避免程序"跑飞"的情况。
- The power dissipated by the address bus is the important power dissipation source of the DSP. 地址总线的功耗是DSP功耗的重要来源。
- A 'real' address, the value that must be placed on the system address bus to select a physical memory bank or device. 物理地址：真实的地址，其值必须被置于系统地址总线中用于选择物理存储位置或者设备。
- The address is transmitted to the memory through a set of parallel wires called an address bus. 向存储器传送地址是经过一组为地址总线的并行导线进行的。
- The actual address that is placed on the address bus when accessing a memory location or register. 当访问内存位置或寄存器时,在地址总线上的真实的地址。
- This article introduces a way to realize dynamic address size in IPV6 datagram. In the improved datagram, only 64 bits address size is fixed other than 128 bits in IPV6, and an optional extension address header is attached after base header. 介绍了在IPV6中实现动态地址长度的方案 ;在改进后的IPV6数据报中仅有 6 4位地址是固定的 ;超过 6 4位的地址形成一个单独的头部 ;此可选的扩展地址头部紧排在IPV6数据报基本头部之后 .
- A novel adaptive-offset bus encoding method was presented for reducing the power dissipation of highly capacitive memory address bus. 为了降低大负载地址总线的功耗;提出了一种新的低功耗自适应偏移量总线编码方法.
