您要查找的是不是：
- axle drive pinion shaft 车轴主动小齿轮轴
- Remove the universal joint strap bolts at the pinion shaft yoke. 在小齿轮轴轴轭处拆卸万向节扣夹螺栓。
- Refer to Drive Pinion Bearing Pre-Load Adjustment. 参阅驱动小齿轮轴承预荷调整。
- Hold the yoke with Wrench 67Remove the pinion shaft nut and washer. 用扳手6719握住轴轭。拆下小齿轮轴螺帽和垫圈。
- Worn teeth on ring gear or drive pinion gear. 环形齿轮或驱动小齿轮上齿磨损。
- End play in drive pinion bearings. 驱动小齿轮轴承的端隙。
- The pinion shaft runs in porous bronze bearing bushes. 小齿轮轴运行多孔青铜轴承衬套。
- The drive pinion is beveled at 45 degrees and engages the ring gear, which is also beveled at 45 degrees, causing the ring gear to revolve at 90 degrees to the drive shaft. 该驱动器齿轮是斜45度和参与的齿圈，这也是斜角在45摄氏度，造成齿圈旋转90度的传动轴。
- Seal air is injected into the labyrinth seals located at the main motor shaft (top and bottom) and at the pinion shaft driving the motor. 密封空气被注入到主马达轴（顶部和下部）和驱动马达的齿轮轴的迷宫式密封里。
- differential spur drive pinion cross shaft 差速[减速]器主动齿轮横轴
- A pinion shaft, the rack shaft, and a rack guide holder are assembled in a housing, and an adjust screw is strongly tightened to press the rack guide holder toward the rack shaft under an overload. 齿轮轴、齿条轴和齿条导向支架安装于壳体内，并且调节螺杆在载荷作用下非常紧地将齿条导向支架压向齿条。
- The ring gear is attached to the differential case so that the ease rotates with the ring gear when the latter is driven by the drive pinion. 冠状齿轮与差速器壳相连,这样当冠状齿轮由传动齿轮驱动转动时,差速器壳也转动。
- An over-running clutch on the drive pinion prevents the starter from being driven by the engine once it starts. 在驱动小齿轮上的一个超转离合器可避免启动马达被引擎带动，一旦引擎启动了。
- wheel cylinder adjusting pinion shaft 轴闸储气筒调准小齿轮轴
- The driving power enters the differential through the drive pinion on the end of the propeller shaft. The drive pinion is meshed with a large ring gear so that the ring gear revolves with the pinion. 也就是说,驱动力是从传动轴末端的传动齿轮输送到差速器的。传动齿轮与一个很大的冠状齿轮啮合,传动齿轮驱动冠状齿轮。
- axle drive pinion adjusting sleeve 车轴传动小齿轮调整套
- differential drive pinion bearing cage 差速器主动小齿轮轴承罩
- differential drive pinion cage bearing 差速器主小齿轮轴承罩
- differential drive pinion bearing 差速器主动小齿轮轴承
- differential drive pinion bearing lock 差速器主动齿轮轴承锁
