您要查找的是不是:
- In this case, the continuous phase is aqueous and the dispersed phase is oil. 就这种情况来说,虽然连续相是水,分散相是油。
- The application and development of polymer blend alloys with laminar dispersed phase were reviewed with 23 refrences. 最后,叙述了永久抗静电层状分散聚合物合金的制备及其应用进展。
- During the initial stages of blending, the dispersed phase forms sheets at first, then breaks into submicron particles. 就国外近期研究内容,介绍了熔融共混过程初期的形态结构发展模式。
- The variation of the operating condition did not change the distributive range magnitude of the dispersed phase droplet. 螺杆转速和挤出机产量的变化对末端分散相液滴直径的分布范围影响不大。
- Methods Nifedipine sustained-released tablets were made with spray-dried solid dispersed phase of NFP and PVP mixed with HPMC. 方法用喷雾干燥法将硝苯地平和聚乙烯吡咯烷酮制成固体分散物,再加入羟丙基甲基纤维素等制得硝苯地平缓释片。
- By adding little amount of SMAH, the blends showed a typical "sea-island" morphology, and the dispersed phase dispersed uniformly, ... 而加入少量SMAH后的合金呈典型的"海-岛"结构,分散相分布均匀,断面呈现大量塑性变形的韧性断裂特征。
- The type of motionless mixer can influence the gas holdup, dispersed phase holdup and mass transfer coefficient on some extent. 对于气体搅拌的萃取过程,静态混合器的型式和规格对传质性能和流体力学性能的影响很大。
- PbO_2-matrix composites containing nano-grade TiO_2 as dispersed phase have been obtained on Ti substrate using nano-composite plating technique and were applied to EOP. 用纳米复合电镀技术制备了TiO_2掺杂的PbO_2电极,并利用该电极电解中性电解液制备臭氧。
- By scanning electron microscope(SEM),the morphology of rubber particle being dispersed phase in ethylene\| propylene rubber toughening polypropylene blends is researched. 通过电子扫描电镜(SEM),研究了乙丙橡胶增韧聚丙烯共混物中作为分散相的橡胶粒子的形态。
- Based on the studying of barrier property of laminar blending HDPE/PA blow moulded containers,research progress of dispersed phase morphology of HDPE/PA blends is summarized. 通过对HDPE/PA层状掺混吹塑容器阻渗性能的研究,综述了HDPE/PA共混物分散相形态的研究进展。
- In this paper a method of particle size measurement introduced into the size and shape measurement of dispersed phase in polymer blend is found feasible. 本文将颗粒大小测定方法引入到高分子共混物的分散相尺寸测定中,验证了这是表征分散相尺寸可行的方法。
- The results showed that the fibrillating of dispersed phase enhanced with the increase of draw rate, but no visible change in diameter of fibers was observed. 结果表明,随著牵引速度的提高,纤维状分散相所占比例增加,但纤维直径无明显变化;
- Polypropylene(PP) and polyamide 6(PA6) were blended and extruded with a single screw extruder, PA6 being the dispersed phase could form microfibrils in PP matrix. 将聚丙烯(PP)与尼龙6(PA6)共混,在挤出加工中PA6作为分散相可以在PP基体中成纤。
- Abstract: Polypropylene(PP) and polyamide 6(PA6) were blended and extruded with a single screw extruder, PA6 being the dispersed phase could form microfibrils in PP matrix. 文摘:将聚丙烯(PP)与尼龙6(PA6)共混,在挤出加工中PA6作为分散相可以在PP基体中成纤。
- Abstract: A high water absorbent polyacrylic acid was obtained by inverse suspension polymerization in the system of cyclohexane as linked phase and water as dispersed phase. 摘 要: 环己烷为连续相,水为分散相,采用反相悬浮聚合法合成了聚丙烯酸高吸水性树脂。
- The results show that grafting agent HEMA could enable the grafting of dispersed phase onto the continuous phase to form a complex network, thus improve its boumdary face co... 结果表明,接枝剂HEMA可使分散相接枝到连续相中形成复合网络,从而改善其界面的相容性,提高其胶液粘度和初粘力,并可广泛作为制鞋工业用胶。
- The porous PAM was polymerizated by the template of concentration emulsion,in which cyclohexane is the dispersed phase,acrylamide and poly(ethyl glycol) is the continous phase. 通过浓乳液聚合方法制备了具有多孔结构的聚丙烯酰胺(PAM)聚合物,以环己烷作为分散相,丙烯酰胺单体作为连续相,聚合后制备出具有多孔结构的PAM聚合物。
- The morphologies, choice of materials, processing conditions and functional properties of polymer blend alloys with laminar dispersed phase were summarized. 综述了层状分散形态聚合物合金的形态特征、材料选择、成型加工条件,以及层状分散形态聚合物的功能性。
- It was shown that content of ethyl cellulose should not less than 0.2 g in this experiment; the suitable adding speed of dispersed phase and the speed of stirring are about 25 mL/min and 120 r/min, respectively. 研究表明:对实验所用比例,乙基纤维素的用量应不少于0.;2 g,适宜的分散相加入速度为25 mL/min,适宜搅拌速度为120 r/min。
- In order to confirm the conclusion, the effects of some factors, such as the molar ratio of water to the surfactant, the percentage of glycerol in the dispersed phase, on the transport were also studied and the same conclusion was obtained. 为进一步证实上述结论,还对影响金属离子在微乳凝腋中传质的各种因素(如微乳液中水与表面活性剂的摩尔比值、分散相中甘油与水的配比等)进行了研究,结果也证实了上述结论。