您要查找的是不是:
- To design, fabricate and repair test fixture. 设计;制作和修理测试机架.
- To plan and control the assumption of test fixture materials. 计划和控制测试机架原材料。
- The requirement for a good test fixture is maximum stiffness for the lightest possible weight. 一台好的试验固紧装置应该是重量轻而刚度大。
- Direct coupled gearbox, chain and sprocket, “V" belt drive systems are available. 传动方式可以是直联式,链传动或三角皮带传动。
- Have rich experience on test fixture building, able to build pneumatic controlled fixture is prefer. 具有丰富的测试治具制作经验,懂气动控制治具制作优先。
- To prevent transients, always turn the source off while switching contacts in and out of the test fixture. 为了避免发生瞬变现象,一定要先将电流源关闭,然后再把接点接入测试夹具或将其断开。
- DUT is placed in test fixture such a diode, transistors, microstrip circuit and so on. 被测件放在测试夹具里,如二极管、晶体管、微带电路等。
- Figure 2-12 shows a high mega-ohm resistor (RDUT) supported on two insulators mounted in a metal test fixture. 图2-12示出了测试夹具上由两个绝缘子支撑的高阻器(RDUT)。
- Again, it may be more economical to cut the cables in half, then permanently connect the cut ends to the test fixture. 同样,若将电缆分为两部分,然后将被截断的一端永久性地连接到测试夹具,则更经济。
- The first step to verify the system requires that resistors of known value be placed in the test fixture. 验证系统的第一步需要将一个已知阻值的电阻器置于测试夹具中。
- In this paper, basic transmission modes of electro-magnetic wave are discussed, the features for three transmission methods namely solenoidal, toroidal and direct coupled are analyzed in comparison. 概述了电磁波发射传输的基本方式,对比分析了螺线管发射、环形线圈偶合与直接偶合方法的特点。
- If mass-terminated cables are used, mating receptacles can be mounted at the test fixture. 如果采用接线头电缆,在夹具上则可以安装匹配插座。
- Use high-reliability, fail-safe interlock switches to disconnect power sources when a test fixture cover is opened. 采用高可靠性、自动防止故障的联锁开关,在夹具外罩被打开时能够自动断开电源。
- METHODS To direct coupling, spacer was used to join insulin and mitoxantrone. 方法直接偶联以及通过间隔基连接米托蒽醌和胰岛素。
- However, it may be more economical to cut mass-terminated cables in half and hardwire the individual wires to the test fixture. 然而,若将接线头电缆分为两部分,然后将独立的导线硬连接至夹具,则更加经济。
- The Model 8009 employs a safety interlock to prevent the high voltage from being applied to the electrode until the test fixture lid is closed. 8009型采用了一种安全互锁机构,在测试夹具的盖子关闭之前,高电压不能施加到电极上。
- direct coupled transistor logic circuit 直接耦合晶体管逻辑电路
- Can be used for probe board and loading board of ICT、ATE and different kinds of functional test fixture, AOI plate fixture and other anti-static fixture or equipment. 用作ICT/ATE测试夹具针板、载板、各种功能测试夹具的针板和载板,以及AOI拖板治具和各种抗静电要求较高的治具或者设备。
- Direct Coupled Shunt Feed PDM Broadcast Transmitter 直流耦合并馈PDM广播发射机
- From the control box, burning me, burning lights, electromagnetic valve, high-pressure ignition, plastic goods test fixture, gas pipes and signal the line of control components. 由控制箱、燃烧箱、燃烧灯、电磁阀、高压点火器、塑料试品夹具、煤气管和信号控制线组成。