您要查找的是不是:
- Compatibility will require that the girder deflection at B be zero. 根据协调性的要求,梁在B点的挠度应为零。
- Find the value of the bending stress and the deflection at the center if the ribs are omitted. 如果略去肋条,求中心处的弯曲应力和挠度之值。
- Ultimate load designs according to the yield-line or strip methods do not guarantee safety against cracking or excessive deformation. 接屈服线法或条带法的极限荷载设计不能完全保证抗裂或防止过度变形。
- The entire rotating assembly shall be designed with sufficient rigidity for minimal shaft deflection at extreme pump operating conditions. 整个旋转总装都应该具有足够的硬度,即使在极端的泵运行环境下,所产生的轴偏差也是最小的。
- The experimental results indicate that the ultimate load decreases with increase of perforation size. 根据不同开孔尺寸试件的试验结果可知,开孔构件的极限承载力随着开孔高度、宽度的增大而下降。
- The ultimate load of plate girders was analyzed by spline finite strip and plastic hinge method. 摘要用样条有限条塑性铰法分析了板梁的极限荷载。
- Vesic A S.Analysis of ultimate load on shallow foundation[J].Proc ASCE,1973,99(SM1). 李进军;黄茂松;史三元;杜海金.;复合地基桩土应力比与褥垫层厚度关系的试验研究[J]
- Formulas for estimating ultimate load of WMM/SB strengthening columns were given in the thesis. 结果表明,被加固试件的保护层能与核心混凝土共同工作到最后,不出现大片剥落。
- Formulas for predicting ultimate load of WMM strengthening column were provided. 并给出钢丝网砂浆加固素混凝土柱的极限承载力公式。
- It is obvious that a concrete member cracks in tensional area as the external load comes to 14% of its ultimate load or so. 研究表明,当外荷载为极限荷载的14%25左右时,钢骨高强混凝土构件受拉区混凝土开裂;
- A new flow rule was recommended, and it offered a new way for obtaining the approximate solution of the ultimate load with the theorem. 并建议了一种新的流动法则,对应用定理求极限荷载的近似解给出了新的解题思路。
- The evaluation of uncertainty A of the ultimate load indicates the main factor which influences the test results is measurement repeatability. 极限载荷测量不确定度的A类评定结果表明影响测试的主要因素是重复性试验。
- Suitable anchorage systems can avoid sudden debonding failure, increase the ultimate load, but they have little effect on the stiffness. 合适的附加锚固方式可以有效的抑制剥离破坏的发生,还可以提高梁的极限承载力,但对刚度影响不大。
- In this paper, Mohr yield criterion is used to analyze the ultimate load of a strength - differential wedge with the vertical uniformly distributed load on an edge. 利用莫尔屈服准则,对一侧承受均布垂直载荷作用的拉压异性材料楔体进行了极限载荷分析。
- Based on deformation accidents of steel corbel, using the software ALGOR12, the ultimate load capacity of the steel corbel is analyzed in detail under different load modes. 针对某钢牛腿的变形事故,应用软件ALGOR12,对钢牛腿在不同荷载模式作用下的极限承载力进行了分析,得出了相关结论,可为类似结构的设计提供有益的借鉴。
- The thermal deflection at the edge of saw blade and the height of sawing profile on woodpiece reduce when saw blade is tensioned or with different slots at the edge. 锯片外缘开径向槽和锯片经适张处理后,使锯片外缘的热变形明显减小,并使锯片在锯切加工表面残留的锯痕波峰高度降低.
- He arrived at the meeting place beforehand. 他提前到达会面地点。
- The method for analyzing ultimate load capacity of steel curved beam with degenerated three-dimensional solid virtual laminated beam element is presented. 提出采用三维实体退化虚拟层合梁单元计算钢曲梁极限承载力的方法。
- It is necessary that he be sent there at once. 有必要马上派他到那里去。
- She is always so surly; she never smiles at anyone. 她总是那麽个坏脾气,对谁也没有一个笑脸。