您要查找的是不是:
- cylindrical pipe thread tap 圆柱管丝锥
- pipe thread tap 管丝锥
- That pipe thread is bad. Use another one instead. 那个钻杆的丝扣坏了,换另外一根。
- A 3/4" NPT pipe thread has an outside diameter - OD - of 1.050 inches. 例如:一个标准为3/4"NPT的管外部直径为1.;050英寸。
- Drill pipe threads are not cleaned in that way. 钻杆丝扣不是那样清洗的。
- Schroeder SKB's are available with pipe thread connections s ranging from 1 to 3 inches. 施罗德SKB的管螺纹连接s不等,从1至3英寸。
- However, when it is used, the prism film light guide made by 3M company must be rolled into a cylindrical pipe with a prism film made by microcopy technique, which makes a seam at the joint of the prism films and the leak of light. 现有的棱镜薄膜导光管,特别是由美国3M公司生产的棱镜膜导光管是由采用微复制工艺(Microcopy)制成的棱镜薄膜卷绕而成,因而在薄膜的接头处存在着缝隙,从而在一定程度上影响了导光管的效率。
- Due to the existence of electric submersible pump Kau, so connected in the pipe thread Department has set up anti-down block. 因电潜泵存在倒扣问题,所以在管螺纹联接处设置了防倒块。
- special taper thread tap for gas cylinder 气瓶专用锥形螺纹丝锥
- Apply pipe dope sparingly on pipe threads, never on valve threads. 在管道螺纹上涂敷螺纹油,但是不要在阀门螺纹上涂螺纹油。
- Needle valves have NPS / internal pipe threaded ends. 针形阀配置NPS内管螺纹连接端口。
- Tapered pipe threads produce radial stress in female fittings. 锥管螺纹在内螺纹内会产生径向应力。
- The general taps are right-hand thread.Please specify if some left-hand thread taps are needed. 丝锥通常生产右扣螺纹,如需左扣螺纹应在订货时说明。
- If pipe dope is used, apply sparingly on pipe threads, neveron valve threads. 在管道螺纹上只能少量使用管道粘接剂,但是在阀门螺纹上绝对不能使用管道粘接剂。
- If the drill pipe threads become rusty, rust will have to be cleaned. 如果钻杆丝扣生锈,必须清除掉。
- Specifes basic thread form, taper, and tolerances of general purpose tapered pipe threads (metal). 规范通用锥管螺纹(金属)的基本螺纹形式,锥度,以及公差。
- It may take an hour to wind off all the thread. 把所有线都松下需一个小时。
- Talking abaut pipe thread and its application 谈谈管螺纹及其应用
- The thread seems to match the cloth. 这线和这布似乎很相称。
- Specifications ranging form 15mm to 150mm. The pipe threads have two systems: English and American. 规格由15MM150MM,管件分英制和美制螺纹两种。