您要查找的是不是：
- Application of mechanism of automatic sprue cutting by ejector pin to thermosetting plastics injection mould 推杆自动切断浇口机构在热固性塑料注射模中的应用
- cutting by ejector pin 切断推杆
- Two scenes were cut by the censor. 有两个镜头被审查员剪掉了。
- The runner system was ejected by deviating hole and spherical ejector pin automatically. 浇注系统凝料的脱出采用了斜拉孔、球形拉料杆自动脱料机构。
- A small ravine, especially one cut by a torrent. 冲沟，激流峡谷狭小深谷，尤指由激流冲刷而形成
- All the prices have been cut by about $5. 所有价格都降了5美元左右。
- His salary has been cut by ten per cent. 他的薪金减少了百分之十。
- Does this part need an ejector pin or an ejector bar? Can we add an ejector blade? 请问产品这个面可否加顶针或顶块?产品允许加扁顶针吗?
- Her hand was cut by a fragment of glass. 她的手被一块玻璃碎片划破了。
- Design of vent system includes vent groove,vent plug and clearance of ejector pin. 介绍了热芯盒模具分型面排气槽、排气塞以及推杆间隙排气等排气系统设计方法。
- A small ravine,especially one cut by a torrent. 冲沟，激流峡谷狭小深谷，尤指由激流冲刷而形成
- Cut by irregular valleys and hills. 切割的被不规则的山、谷切割的
- The submarine gate and two stage mold unloading mechanism of cavity plate and ejector pin are adopted in the injection mould. 推出塑件时,先依靠与塑件接触面积大的型腔板推动塑件,使塑件先与型芯分离,然后推杆将塑件推出型腔。
- The smelting time has been cut by one-tenth. 熔练时间缩短了十分之一。
- After mold opening, this pin will function as an ejector pin and ejects the sprue from a sprue bush. Also it releases gas contained in molten plastic. 开模以后，拉料杆像顶针一样将浇注凝料从浇口套内顶出，同时也释放融料中的气体。
- The line AC is cut by line PQ at a point. AC线和PQ线交于一点。
- HOT RUNNER SYSTEM,TEMPERATURER CONTROLLER. MOLDCOMPONENT（EJECTOR PIN,BLADE EJECTOR.）MULTI-FUNCTION FILTER NOZZLE. HEAT PIPE,OILLESS BEARING. 热浇道系统、温度控制器、模具零配件（射梢、强力型）万能泸嘴、测温表、自润轴承、润滑柱。
- I get my hair cut by a good, inexpensive barber. 我给一位很棒，收费又不贵的理发师剪头发。
- Ulqy is cut by Ichigo's sword and falls. 乌尔被一护用刀砍劈，然后跌落。
- The product has excellent tooling quality and machining performance, so as to alleviate and avoid the deformation of ejector pin because of heat treatment. 该产品具有良好易切削性能和机械加工性能，从而避免了薄壁推管（司筒）因热处理而产生变形。
