您要查找的是不是：
- Standard Test Method for Surface Wettability and Absorbency Sheeted Materials Using an Automated Contact Angle Tester 使用自动接触角测试仪测定表面湿润度和吸收性覆盖材料的标准试验方法
- contact angle tester 接触角试验机
- The polymer film's hydrophile was test with contact angle machine. 利用接触角测试仪分析该聚合膜的亲水性。
- Contact angles are of interest to ducks and swans. 接触角对鸭和天鹅是颇为重要的。
- For hydrophilic materials, the contact angle will be lower than 90 degrees. 亲水性材料的接触角度会低于90度。
- An alternate experimental approach which does not require the direct measurement of contact angle appears to be promising. 有一种可选用的试验方法看来很有希望，它不要求直接测量接触角。
- An alternate experimedirect measurement of contact angle appears to be promising. 有一种可选用的试验方法，它不要求直接测量接触角，看来很有希望。
- Bearing with steep contact angle and intermediate ring, pierced rollers and pin-type steel cages. 带有大接触角以及中隔圈、穿孔滚子和钢支柱式保持架的轴承。
- Bearings having a large contact angle are a special design of the TDI configuration (fig 9). 有大接触角度的轴承是TDI配置的特殊设计(图9)。
- Bearing with large contact angle, intermediate ring between the outer rings and pressed steel cages (fig 9). 带有大接触角度、外圈之间的中隔圈和钢板冲压保持架的轴承(图9)。
- Bearing with steep contact angle, matched inner rings, injection moulded segment cages of polyamide 6,6. 大接触角轴承,配对内圈,注模尼龙6,6分段保持架。
- The time-dependent height,wetting radius and contact angle of the droplet were measured. 实验测量了液滴高度、湿润半径和接触角随时间的动态演化。
- Basom observed the contact angle of water against silane-treated E glass to be about 1. 2 rad. 巴索母观察到水对硅烷处理的E玻璃接触角大约是1.;2弧度。
- Though the linear regression equation,grafting yield of product can be counted directly by contact angle. 推导出的线性回归方程,能通过接触角的测定直接计算出接枝率。
- The existence of MPS is examined by thermogravimetric analysis and contact angle testing. 热重分析和接触角测试验证了粒子表面MPS的存在。
- As the content of BMA increases, the melting point, enthalpy of fusion, dynamic contact angle of copolymer rise. 梳形聚合物的熔点、焓值及静态接触角随着共聚物中BMA含量的升高而升高。
- In this case the water contact angle approaches zero and flow down when the surface leans. 如果玻璃非常平整及非常干净,水滴在玻璃上将自由展开,接触角为零。
- The plant was growing at an angle. 植物呈一定角度生长。
- Its contact angle, water absorption rate, motionless fric-tion coefficient and sliding time are respecivey tested. 对修饰后的材料表面进行接触角、吸水速率、静摩擦系数、滑动时间等指标测定。
- The results showed that the contact angle with water was increased and dispersibility in organic medium was enhanced. 结果表明:改性的超微二氧化钛与水的接触角增大,在有机介质中分散性提高。
