您要查找的是不是：
- common mode errors 共性误差
- common mode error 共模误差
- Most common mode of transmission among Asian Americans. 亚裔美国人最常见的传递模式。
- Its common mode rejection ratio(CMRR) was 65 dB at 100 kHz. 在100kHz时,该系统仍具有65dB的共模抑制比。
- The baculine argument was used as a common mode of argument in those days. 鞭挞的方法是当时常用的一种说服方式。
- The circuit has constant transconductance within the common mode range. 本文设计的电压缓冲器采用了PMOS和NMOS差分对增益放大器，使电路具有较大的共模输入范围和输出摆幅，并在共模输入范围内具有恒定的跨导。
- High attenuation to low frequency,excellent perform ance of common mode and differential mode interfere nce suppression. 极佳的低频段衰减特性，具有良好的共模和差模干扰抑制性能。
- The commonest mode of delivery was vacuum extraction. 研究中最常见的围产情况为胎儿窘迫。
- High attenuation to low frequency,excellent performance of common mode and differential mode interference suppression. 极佳的低频段衰减特性,具有良好的共模和差模干扰抑制性能。
- The amplitude of the circulating bearing current depends on the common mode component of capacitive coupling currents. 循环举止涌流的广阔仰赖电容的联结涌流的通常模态成份。
- Because the output voltage of PWM inverter is dissymmetry instantly, the common mode voltage appears as a result. 由于PWM变频器的三相输出电压在瞬间并不对称，所以导致电机三相定子绕组的电压矢量和不为零，从而出现共模电压。
- High rates of dv/dt and parasitic capacitors to the ground are the reasons for common mode interferences. 高速率的电压变化和对地的分布电容是产生共模干扰的原因。
- The use of representations could be interpreted as a common mode of devising and presenting ritual in the period. 这种对图象的使用也似乎可以被视为一种当时思考和呈现礼仪的方式。
- Either the occlusive mode or common mode of the target is determined by the multitarget occlusion reasoning mechanism. 然后多目标遮挡推理机制确定目标是处于遮挡模式还是正常模式。
- Common Mode Rejection Ratio: The ratio of the input voltage range to the peak-to-peak change in input offset voltage over this range. 共模抑制比,输入电压范围除以该范围内输入失调电压峰峰值。
- Differential signals can help nullify the effects of ground shifts and induced noise signals that can appear as common mode voltages on a network. 差分信号有助于消除在网络中作为共模电压出现的接地偏移和感应噪声信号的影响。
- Three methods to dia gnose differential mode and common mode noise are discussed in this paper,the comparsion of these methods also be presented. 介绍了共模干扰和差模干扰测量的三种方法，并讨论、比较了三种方法各自的优缺点。
- Knowledge without common sense counts for little. 光有学问而无常识，则这种学问无甚价值。
- This common mode biasing can be achieved using the on-chip differential amplifiers, further reducing the external signal conditioning requirements. 此共模偏置可利用片内差分放大器来实现,从而可进一步降低外部信号调理要求。
- This type of error is very common among dabblers. 在浅尝者中这类错误很平常。
