您要查找的是不是:
- combustion air inlet 供给空气于燃烧区
- RAM AIR INLET MECHANICAL LINKAGE. 冲压空气进口机械连杆机构。
- NO_x emission properties during combustion with air staging of differently sized Shenhua coal particles were investigated in an one-dimensional furnace with multipath air inlet. 在多路进风一维炉上,研究不同粒径的神华煤在分级燃烧中氮氧化物的排放规律。结果表明:不分级燃烧时中等粒径煤粉氮氧化物的排放较高;
- Remove the air inlet hose from the throttle body and air cleaner. 从节流阀体和空气滤清器上拆下气流入口软管。
- Turn off supply pressure and observe float drop to open air inlet. 关闭供应压力,观察浮子下降,因此开启空气进口。
- Check found birdstrike on radome and R engine air inlet. 雷达罩和右发进气道口有鸟击痕迹。
- Air inlet throttle valve with pneumatic actuator and positioner. 空气进气节流调节阀:带有气动定位和执行机构。
- Connect the air inlet hose to the throttle body and the air cleaner. 将空气入口软管接至节流阀体和空气滤清器。
- The fuel used for heating is either blast furnace gas or coke oven gas. The combustion air is always preheated to improve fuel utilization. 用来加热的燃料不是高炉煤气就是焦炉煤气。燃烧用风通常要预热,以提高燃料的利用率。
- Manual or motorized designs used to control combustion air up to 25 PSIG (1.7 bar) service. 手动或电动调节设计用来控制压力高达25 PSIG (1.;7 bar)的助燃空气或燃气。
- By regulating the combustion air and burning the first to obtain the best combustion parameters. 通过调节燃烧空气和燃烧头,可以获得最佳的燃烧参数。
- Therefore, the process feed, combustion air, and fuel gas should be preheated as much as possible before considering steam generation in the convection section. 因此,在考虑通过对流生产蒸汽之前,应尽量将过程原料、燃烧空气和燃料气进行预热处理。
- Slowly open vent needle valve just as air inlet opens. Record differential pressure. 当空气进口开启时,慢慢开启排气针形阀。记录压差。
- The SO/SB Shutoff Regulator is used in the gas line to automatically shut off the fuel when the combustion air or any remote signal pressure drops below a predetermined limit. SB切断阀用于燃气管线自动切断燃料,当助燃空气或者任何采样信号的压力低于预设定极限值时,安全且短阀都会自动切断燃料的供应。
- Slowly open needle valve "C" bypass (yellow) just as air inlet opens. Record differential pressure. 正当空气进口打开时,慢慢开启针形阀“C”旁路(黄)。记录压差。
- Separation of the water supply from the air inlet is accomplished by means of a diaphragm seal. 供水与空气的隔离是通过采用隔膜密封的方法实现的。
- Next, let's make the simple panel under the air inlet that we can find on the side. 接下来,让我们作一个简单小组根据空气进说,我们能够找到对的一面。
- Separation of the water supply from the air inlet is accomplished by means of a diaphragm seal . 水供应与空气进口的分离通过隔膜密封的方法实现。
- Requirement: Air inlet must start to open when supply pressure is 1.0 PSI or above. Air inlet must be fully open when supply pressure is atmospheric. 要求:当供应压力达到或超过1.;0PSI时,空气进口必须开始打开。当供应压力达到大气压力时,空气进口必须完全打开。
- By analyzing the operation process of HI TEMP tunnel kiln in home,the thesis puts forward many improving methods and proposes to the fuel, atomizing medium, combustion air and burner etc. 本文通过分析比较国内高温隧道窑的运行操作情况,结合生产实践及对比试验,对影响高温烧成稳定的因素如燃油、雾化介质、燃烧设备、助燃空气等提出了改进办法和建议。