您要查找的是不是：
- The effect of three commercial cold flow improvers (T1, T2 and T3) on the cold flow property of two FCC diesel fuels (A and B) was studied. 摘要 考察了三种市售柴油低温流动性改进剂（T1,T2,T3）对两种催化裂化柴油(柴油A、柴油B)的低温流动性的改善效果。
- And the cold flow properties of diesel fuel were studied by using the technology of photomicrography and thermodynamics. 利用光学显微技术和热分析技术研究了柴油的低温流动性能。
- Advances in research of cold flow properties of diesel fuel 柴油低温流动性能研究进展
- Cold Flow Properties of Diesel with Cold Flow Improver 柴油低温流动性能的研究
- Good flow property and uniformity. 良好的流动性和均匀性。
- cold flow property 低温流动性
- cold flow properties 低温流动性
- Rheology The science that study the flowing property of liquids. 研究液体流动特性的科学。
- Rheology: The science that study the flowing property of liquids. 流动学:研究液体流动特性的科学。
- The diaphragms may become permanently inverted and the elastomeric stem tip can cold flow down the throat of the valve. 横膈膜会永久性的翻转，人造橡胶阀杆尖端会冷变形到阀门的喉管处。
- When the Teflon is squeezed, it responds by “cold flowing. 当特氟纶受到挤压时，它的反应是“冷变形”。
- The experimental results show that difference on flow property exists between CDG and polymer solution. 实验结果表明 ,由于分子结构上的不同 ,交联聚合物溶液在流动性质方面与聚合物溶液间存在明显差异
- ASAC filled NR compound possessed good flow property and similar die swell to that of semi reinforcing carbon black filled compound. ASAC填充NR胶料的流动性好，挤出胀大效应与填充半补强炭黑胶料相近
- Diesel engine operators all over the world benefit from the cold flow improver capabilities of Bell's DEE-ZOL PLUS with Anti-Gel. 同时确保了燃料的流动，并有效防止燃油滤清器堵塞。全球柴油机的操作员都得益于带有抗凝胶功能的贝尔DEE-ZOL PLUS的冷流改进剂。
- So, this slug flow unit model could be used as the basis for further analyzing the flow property of slug flow under rolling condition. 因此，该弹状流单元物理模型是进一步分析摇摆状态下弹状流流动特性的基础。
- For most specialty gases, CTFE is recommended over PTFE because it is less permeable to oxygen and moisture, and evidences less cold flow. 对于大多数特种气体，推荐使用CTFE，而不是PTFE，这是因为CTFE对氧气和水蒸汽的渗透性更差，冷变形也较小。
- Taking this as basis, flow property for the CDG is researched by measuring a few of parameters such as resistance factor and residual resistanc. 在此基础上,从阻力系数、残余阻力系数、传输能力和流动成胶等方面对交联聚合物溶液的流动特性进行了实验研究。
- Some of the other properties to be considered are leak integrity, permeation, cold flow, off-gassing, particle shedding, and cost. 要考虑的一些其它性质是泄露完整性、渗透、冷变形、排气、颗粒脱落和成本。
- Higher melting point resin. Used in cold curing lacquers suitable for improving the flow properties and chemical resistance of epoxy powder coating. 高熔点树脂,用于低温固化涂料,增加粉状涂料的流动性和抗化学腐蚀能力。
- Higher melting point resin. Used in cold curing lacquers suitable for improving the flow properties and chemical resistance of epoxy powder coatings. 高熔点树脂,用于提高粉状涂料的流动性和抗化学腐蚀能力。
